Mathematical Modelling of Wall Films Formed by Impinging Sprays
Authors:
- 1 February 1996
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
This paper presents a mathematical model for the prediction of the dynamic characteristics of wall films formed by impinging sprays. The model takes into account the impingement pressure due to bombardment of impinging droplets, tangential momentum transfer resulting from oblique droplet impingement on the film surface, and the gas shear force at the film surface. The general transport equations of mass, momentum and energy for wall film flows are established in the boundary-layer framework. It is shown that this set of equations can be substantially simplified if local equilibrium occurs and a dimensional analysis is performed to identify the conditions for the applicability of the local equilibrium model. Solution of the full film equations is obtained by an efficient hybrid integral/numerical method, which allows numerical calculations to be performed in a two-dimensional framework. An implicit finite volume scheme is employed for this purpose. The methodology is first tested against some simple problems with analytical solutions. Then assessment is performed against several sources of experimental data for films formed by impinging sprays. Satisfactory agreement is obtained.Keywords
This publication has 11 references indexed in Scilit:
- Liquid Gasoline Behavior in the Engine Cylinder of a SI EngineSAE International Journal of Advances and Current Practices in Mobility, 1994
- Analysis of Impinging Spray Characteristics under High-Pressure Fuel Injection. 1st Report, Measurements of Impinging Spray Characteristics.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 1993
- Calculating hydrodynamics problems for a liquid film flowing radially on a flat horizontal surfaceInternational Journal for Numerical Methods in Fluids, 1991
- Sources of Hydrocarbon Emissions from a Small Direct Injection Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1987
- Approximate equations for forced-convection condensation in the presence of a non-condensing gas on a flat plate and horizontal tubeInternational Journal of Heat and Mass Transfer, 1980
- Jump conditions and entropy sources in two-phase systems. Local instant formulationInternational Journal of Multiphase Flow, 1974
- Unsteady Laminar Film Condensation on Vertical PlateJournal of Heat Transfer, 1963
- An Integral Treatment of Two-Phase Boundary Layer in Film CondensationJournal of Heat Transfer, 1961
- A Boundary-Layer Treatment of Laminar-Film CondensationJournal of Heat Transfer, 1959
- Heat Transfer and Temperature Distribution in Laminar-Film CondensationTransactions of the American Society of Mechanical Engineers, 1956