Clay-Free Synthetic-Based Fluid Provides High-Angle Wellbore Stability with Minimal Dilution and Treatment Requirements
Authors:
- 2 February 2010
- conference paper
- Published by Society of Petroleum Engineers (SPE)
Abstract
A seven-well development program in the Gulf of Mexico presented several drilling and logistical challenges to the Arena Offshore LLC engineering staff. The high-angle (54°-73°) 9-7/8" production intervals had shallow kick-off points (in one instance 70° by 3000 ft TVD, 30° average azimuth change, high of 67°). The complex wellpaths had proven difficult to drill with water-based fluids (WBF). Wellbore stability and torque and drag issues added to non-productive time (NPT). Previous wells drilled with WBF experienced slow penetration rates, multiple wiper trips, and one lost directional bottomhole assembly (BHA). The decision was made to use a synthetic-based fluid (SBF) on the seven-well project, but deck space and pit capacity constraints meant that the selected SBF would have to perform well with minimal dilution and product additions. To help improve tolerance for increased low gravity solids content (>6%), the operator displaced the well with a clay-free SBF after setting surface casing at ± 3000 ft TVD. The system contained zero organophilic clay or lignite additives, so that the solids content was inherently lower than that of conventional SBFs. In addition, the fluid required one-third fewer products than conventional SBFs, resulting in fewer crane lifts and a smaller footprint on offshore rigs. The system can be characterized as "emulsion-based". The emulsion chemistry can provide the yield point values and gel strengths required for good suspension and sag prevention, while exhibiting shear-thinning behavior for rapid gel-to-flow transitions when needed. The clay-free SBF can run with a low synthetic oil-to-water ratio (SWR) in the range of 70/30 to 75/25 SWR as compared to the 80/20 SWR typically needed for conventional SBFs. On the Arena project, the system performed reliably despite an average 8.1% low gravity solids (LGS) content. Gels remained low and flat, even when the LGS content reached 15% on one well. The lower SWR values and reduced base oil dilution requirements helped keep fluid maintenance costs low. The use of the clay-free SBF allowed the operator to drill the wells considerably faster, at times drilling over 2,000 ft. per day despite the high percentage of LGS. No wellbore instability issues occurred, trips went smoothly and casing was run to bottom on every well. Four of the seven original wells reached total depth at 21% below AFE cost, and several sidetracks were drilled for geologic reasons using the same clay-free system.Keywords
This publication has 2 references indexed in Scilit: