OH* chemiluminescence measurements in a direct injection hydrogen-fuelled internal combustion engine
Author:
- 1 April 2007
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 8 (2) , 185-204
Abstract
In an optically accessible single-cylinder engine fuelled with hydrogen, OH* chemiluminescence imaging is used to measure flame propagation characteristics, cycle-to-cycle variability, and to evaluate global trends related to in-cylinder mixture formation. The experiments include measurements for engine operation with hydrogen injection in-cylinder either prior to or after intake valve closure (IVC). Pre-IVC injection is used to produce a near-homogeneous mixture in-cylinder and to establish a baseline comparison for post-IVC injection. In order to assess the effects of injection pressure on mixture distribution and combustion, two injection pressures of 2.5 and 10 MPa are used for post-IVC injection. High flame propagation speeds and low cycle-to-cycle variability are observed for pre-IVC injection. For post-IVC injection with start of injection (SOI) coincident with IVC, results are similar to pre-IVC injection. With retard of SOI from IVC, mixture inhomogeneities increase monotonically for both injection pressures, but the spatial and temporal development of the mixture distribution differs significantly. Next, using the pre-IVC injection data sets, a functional relationship between the OH* chemiluminescence intensity, cylinder pressure, and equivalence ratio is determined. This functional relationship is then used to extract a semi-quantitative measure of the maximum line-of-sight averaged fuel-air ratio from the OH* chemiluminescence images acquired for post-IVC injection.Keywords
This publication has 17 references indexed in Scilit:
- The hydrogen-fueled internal combustion engine: a technical reviewInternational Journal of Hydrogen Energy, 2006
- Local measurements of the time-dependent heat release rate and equivalence ratio using chemiluminescent emission from a flameCombustion and Flame, 2004
- A global reaction model for oh* chemiluminescence applied to a laminar flat-flame burnerCombustion Science and Technology, 2003
- Low pressure flame determinations of rate constants for OH(A) and CH(A) chemiluminescenceCombustion and Flame, 2002
- Local A/F Measurement by Chemiluminescence OH*, CH* and C2* in SI EngineSAE International Journal of Advances and Current Practices in Mobility, 2001
- Measurement of the Flame Lift-Off Location on DI Diesel Sprays Using OH ChemiluminescenceSAE International Journal of Advances and Current Practices in Mobility, 2001
- Systematic measurements of OH chemiluminescence for fuel-lean, high-pressure, premixed, laminar flamesFuel, 2001
- Sensors for measuring primary zone equivalence ratio in gas turbine combustors1999
- Experimental and computational study of CH, CH*, and OH* in an axisymmetric laminar diffusion flameSymposium (International) on Combustion, 1998
- The effect of fuel injection on NOx emissions and undesirable combustion for hydrogen-fuelled piston enginesInternational Journal of Hydrogen Energy, 1983