Systematic comparison of different dopants in thin film hematite (α-Fe2O3) photoanodes for solar water splitting
- 9 December 2015
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 4 (8) , 3091-3099
Abstract
Numerous studies have shown that the addition of different impurities as dopants in hematite (α-Fe2O3) photoanodes improves water photo-oxidation. The improvements observed may have resulted from electronic and/or catalytic effects, but also from changes in the layer morphology and microstructure induced by different precursors. The latter could be quite substantial, especially in mesoporous layers produced by chemical routes, making it difficult to make a systematic comparison between different dopants. This work attempts to overcome this difficulty by comparing different dopants in thin films produced by pulsed laser deposition (PLD), a physical deposition method that produces highly reproducible films with no significant variations in the microstructure and morphology. This enables systematic comparison of the effect of different dopants without spurious side effects due to variations in the microstructure and morphology. Thus, we examine the effect of Sn, Nb, Si, Pt, Zr, Ti, Zn, Ni and Mn dopants on the photoelectrochemical properties of thin (∼50 nm) film hematite photoanodes deposited by PLD from Fe2O3 targets doped with ∼1 cation% of the respective dopants onto FTO coated glass substrates. The morphology and microstructure of the films were nearly the same, independent of the different dopants in the films. The Sn-doped hematite photoanode outperformed all the other photoanodes that were examined in this work in both the photocurrent and photovoltage, achieving the highest photocurrent (∼1 mA cm−2) and the lowest onset potential (∼1.1 VRHE). Based on a figure of merit that accounts for the maximum photocurrent × photovoltage product (i.e., power) as well as the potential at which the maximum power is achieved, our photoanodes ranked in the following order: Sn > Nb > Si > Pt > Zr > Ti > Zn > Ni > Mn. These observations are not always consistent with other reports on doped hematite photoanodes, suggesting that the photoelectrochemical properties and performance depend not only on the identity of the dopant but also on the dopant concentration, distribution and the morphology and microstructure of the photoanode in which the dopant is incorporated.Keywords
Funding Information
- Israeli Centers for Research Excellence (152/11)
- European Research Council (617516)
This publication has 32 references indexed in Scilit:
- The potential versus current state of water splitting with hematitePhysical Chemistry Chemical Physics, 2015
- Hematite‐Based Water Splitting with Low Turn‐On VoltagesAngewandte Chemie International Edition, 2013
- Single-crystalline, wormlike hematite photoanodes for efficient solar water splittingScientific Reports, 2013
- Identifying champion nanostructures for solar water-splittingNature Materials, 2013
- Resonant light trapping in ultrathin films for water splittingNature Materials, 2012
- Enhancement in the Performance of Ultrathin Hematite Photoanode for Water Splitting by an Oxide UnderlayerAdvanced Materials, 2012
- The Role of Cobalt Phosphate in Enhancing the Photocatalytic Activity of α-Fe2O3 toward Water OxidationJournal of the American Chemical Society, 2011
- Solar Water Splitting: Progress Using Hematite (α‐Fe2O3) PhotoelectrodesChemSusChem, 2011
- Powering the planet: Chemical challenges in solar energy utilizationProceedings of the National Academy of Sciences of the United States of America, 2006
- Electrochemical Photolysis of Water at a Semiconductor ElectrodeNature, 1972