Characteristics in SiC-CMP using MnO2 slurry with Strong Oxidant under Different Atmospheric Conditions
Authors:
- 18 July 2013
- journal article
- Published by Springer Nature in MRS Proceedings
- Vol. 1560
Abstract
Semiconductor technology is the key point of the information society. However, as technology developing, the traditional semiconductor material such as silicon (Si) could not meet the demand of the society. Therefore, the next generation semiconductor material silicon carbide (SiC) is widely concerned. Compared to Si, SiC has some superior physical and chemical properties. On the other hand, it is difficult to polish SiC wafers due to the chemical, mechanical, and thermal stability. To achieve high-efficient CMP processing of SiC substrates, oxygen gas was introduced which might increase removal rates. MnO2 slurry was selected instead of silica slurry and strong oxidant KMnO4 was used to improve SiC-CMP process as an additive. In this paper, the effect of oxidant was inspected first. Meanwhile, we carried out the CMP experiment with the new type CMP machine to control the processing atmospheres including types of gases and gas pressures. As conclusions, oxygen and high atmospheric pressure can increase the removal rate in MnO2 slurry. KMnO4 additive has a great effect on increase of the removal rate. One of additional interesting results is that there seems to be the optimum mixture ratio of N2 and O2 gases to achieve a higher removal rate of SiC wafer.Keywords
This publication has 4 references indexed in Scilit:
- Planarization of C-face 4H-SiC substrate using Fe particles and hydrogen peroxide solutionPrecision Engineering, 2012
- Formation of wide and atomically flat graphene layers on ultraprecision-figured 4H-SiC(0001) surfacesSurface Science, 2011
- Basic Characteristics of a Simultaneous Double-Side CMP Machine, Housed in a Sealed, Pressure-Resistant ContainerKey Engineering Materials, 2010
- A New Bell-Jar Type Controlled Atmosphere Polishing (CAP) Machine and Its CharacteristicsJournal of the Japan Society for Precision Engineering, Contributed Papers, 2004