A Reconfigurable System Approach to the Direct Kinematics of a 5D.o.fRobotic Manipulator
Open Access
- 1 January 2010
- journal article
- research article
- Published by Hindawi Limited in International Journal of Reconfigurable Computing
- Vol. 2010, 1-10
Abstract
Hardware acceleration in high performance computer systems has a particular interest for many engineering and scientific applications in which a large number of arithmetic operations and transcendental functions must be computed. In this paper a hardware architecture for computing direct kinematics of robot manipulators with 5 degrees of freedom (5D.o.f) using floating-point arithmetic is presented for 32, 43, and 64 bit-width representations and it is implemented in Field Programmable Gate Arrays (FPGAs). The proposed architecture has been developed using several floating-point libraries for arithmetic and transcendental functions operators, allowing the designer to select (pre-synthesis) a suitable bit-width representation according to the accuracy and dynamic range, as well as the area, elapsed time and power consumption requirements of the application. Synthesis results demonstrate the effectiveness and high performance of the implemented cores on commercial FPGAs. Simulation results have been addressed in order to compute the Mean Square Error (MSE), using the Matlab as statistical estimator, validating the correct behavior of the implemented cores. Additionally, the processing time of the hardware architecture was compared with the same formulation implemented in software, using the PowerPC (FPGA embedded processor), demonstrating that the hardware architecture speeds-up by factor of 1298 the software implementation.Keywords
This publication has 4 references indexed in Scilit:
- An FPGA-Based Multiple-Axis Motion Control ChipIEEE Transactions on Industrial Electronics, 2008
- A Study on the Design of Floating-Point Functions in FPGAsLecture Notes in Computer Science, 2003
- Evaluation of CORDIC Algorithms for FPGA DesignJournal of Signal Processing Systems, 2002
- Parallel processing for robot dynamics computationsParallel Computing, 1995