The tin content of lead inclusions in ancient tin-bronze artifacts: a time-dependent process?
Open Access
- 10 May 2024
- journal article
- research article
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 57 (3) , 700-706
Abstract
In antiquity, Pb was a common element added in the production of large bronze artifacts, especially large statues, to impart fluidity to the casting process. As Pb does not form a solid solution with pure Cu or with the Sn–Cu alloy phases, it is normally observed in the metal matrix as globular droplets embedded within or in interstitial positions among the crystals of Sn-bronze (normally the α phase) as the last crystallizing phase during the cooling process of the Cu–Sn–Pb ternary melt. The disequilibrium Sn content of the Pb droplets has recently been suggested as a viable parameter to detect modern materials [Shilstein, Berner, Feldman, Shalev & Rosenberg (2019). STAR Sci. Tech. Archaeol. Res. 5, 29–35]. The application assumes a time-dependent process, with a timescale of hundreds of years, estimated on the basis of the diffusion coefficient of Sn in Pb over a length of a few micrometres [Oberschmidt, Kim & Gupta (1982). J. Appl. Phys. 53, 5672–5677]. Therefore, Pb inclusions in recent Sn-bronze artifacts are actually a metastable solid solution of Pb–Sn containing ∼3% atomic Sn. In contrast, in ancient artifacts, unmixing processes and diffusion of Sn from the micro- and nano-inclusions of Pb to the matrix occur, resulting in the Pb inclusions containing a substantially lower or negligible amount of Sn. The Sn content in the Pb inclusions relies on accurate measurement of the lattice parameter of the phase in the Pb–Sn solid solution, since for low Sn values it closely follows Vegard's law. Here, several new measurements on modern and ancient samples are presented and discussed in order to verify the applicability of the method to the detection of modern artwork pretending to be ancient.Keywords
This publication has 19 references indexed in Scilit:
- On the deviation from the Vegard's law for the solid solutionsSolid State Communications, 2020
- Microstructure and chemical composition of a Sardinian bronze axe of the Iron Age from Motya (Sicily, Italy)Materials Characterization, 2019
- Profex: a graphical user interface for the Rietveld refinement programBGMNJournal of Applied Crystallography, 2015
- Beamline P02.1 at PETRA III for high-resolution and high-energy powder diffractionJournal of Synchrotron Radiation, 2015
- The effect of microstructure and lead content on the tribological properties of bearing alloysProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2013
- Whole powder pattern decomposition methods and applications: A retrospectionPowder Diffraction, 2005
- Lattice parameter measurement using Le Bail versus structural (Rietveld) refinement: A caution for complex, low symmetry systemsPowder Diffraction, 2005
- The lattice parameter of α-bronzes as a function of solute content: application to archaeological materialsMaterials Science and Engineering: A, 2005
- Vegard’s lawPhysical Review A, 1991
- Metastable phase equilibria in the lead-tin alloy system: Part I. ExperimentalMetallurgical Transactions A, 1989