Filler effect on the recoil kinetics of drawn polystyrene
Authors:
- 1 February 1981
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 21 (3) , 151-154
Abstract
Recovery experiments above Tg have been performed on glass bead and short glass fiber polystyrene composite sheets obtained from extrusion and subsequent hot drawing. A shift procedure has been applied to recoil data using the Williams‐Landel‐Ferry (WLF) equation with the same values of C1 and C2 used for unfilled polystyrene. The data reported show that an improvement of the dimensional stability of a drawn thermoplastic material can be obtained by adding very low volume percentage of fibers. Moreover, all the recoil data have been reduced to a unique generalized master curve which takes into account the draw ratio, the filler content, and geometry, using a fractional distance from equilibrium as a measure of the recovery. These results indicate that the presence of the filler does not affect the recoil kinetics of the polymeric matrix.Keywords
This publication has 8 references indexed in Scilit:
- The effect of hot drawing on the properties of short fiber reinforced extruded sheetsPolymer Engineering & Science, 1979
- Orientation and Shrinkability in PolymersInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1977
- Elongational viscosity of microbead suspensionsPolymer Engineering & Science, 1975
- Extensional flow behavior of polymer solutions and particle suspensions in a spinning motionInternational Journal of Multiphase Flow, 1974
- The influence of carbon black on the extrusion characteristics and rheological properties of elastomers: Polybutadiene and butadiene–styrene copolymerJournal of Applied Polymer Science, 1974
- Rheological properties of calcium carbonate-filled polypropylene meltsJournal of Applied Polymer Science, 1974
- Viscoelastic Properties of Filled PolymersInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1972
- Barus effect in filled polymer meltsJournal of Applied Polymer Science, 1965