Numerical investigation of conjugate heat transfer in the presence of two fluid separated by a rigid wall
- 15 July 2020
- journal article
- research article
- Published by Wiley in Heat Transfer
- Vol. 49 (8) , 4981-5001
Abstract
This study presents a series of numerical simulations of conjugate heat transfer within square cavity horizontally divided into two regions by a conductive wall. The two fluids are subjected to different boundary conditions. Cold fluid (Pr1) enters the upper part through an inlet (h1) and exits it via an outlet (h2), while the lower part has been heated from bellow and filled with another fluid (Pr2 = 7). The finite volume method has been used to predict thermal and hydrodynamic mechanisms in both fluid regions of cavity and at partition wall. Effect of inlet/outlet location has been considered according to two configurations. Influence of Reynolds number (50 ≤ Re ≤ 1000), Grashof number (Gr = 104 and Gr = 5 × 105), fluid‐1 Prandtl number (Pr1), and thermal conductivity ratio () has been investigated. Analysis of results was done based on isotherms, streamlines, local, and average Nusselt number. The results show that one of two configurations guarantee a higher Nusselt number. Higher heat transfer rate was obtained by increasing Reynolds and Grashof numbers. Also, it has been found that the effect of upper fluid flow regime on lower fluid flow is more pronounced with a very low thermal conductivity ratio.Keywords
This publication has 33 references indexed in Scilit:
- Thermal Analysis and Thickness Optimization of Two-Cavity Thermal Insulator in BuildingsArabian Journal for Science and Engineering, 2017
- Conjugate heat transfer simulations of pulsed film cooling on an entire turbine vaneApplied Thermal Engineering, 2016
- Comparative study on steady and unsteady conjugate heat transfer analysis of a high pressure turbine bladeApplied Thermal Engineering, 2016
- Modeling of the thermal performance of air-filled partitioned enclosures: Effects of the geometry and thermal propertiesJournal of Building Physics, 2014
- Detailed numerical simulation of coupled heat transfer by conduction, natural convection and radiation through double honeycomb wallsBuilding Simulation, 2012
- Numerical simulation by the FVM of coupled heat transfers by conduction, natural convection and radiation in honeycomb’s hollow bricksBuilding Simulation, 2009
- Transfer function coefficients for time varying coupled heat transfers in vertically heated hollow concrete bricksBuilding Simulation, 2008
- Numerical simulation of coupled heat transfers by conduction, natural convection and radiation in hollow structures heated from below or aboveInternational Journal of Thermal Sciences, 2008
- Heat transfer in ground heat exchangers with groundwater advectionInternational Journal of Thermal Sciences, 2004
- The combined effects of longitudinal heat conduction, flow nonuniformity and temperature nonuniformity in crossflow plate-fin heat exchangersInternational Communications in Heat and Mass Transfer, 1999