Characterisation of WC—12Co Thermal Spray Powders and HPHVOF Wear Resistant Coatings
Authors:
- H. L. de Villiers LovelockHLH. L. de Villiers Lovelock
- J. KindsJKJ. Kinds
- P. M. YoungPYP. M. Young
- 1 January 1998
- journal article
- research article
- Published by SAGE Publications in Powder Metallurgy
- Vol. 41 (4) , 292-299
Abstract
Fourteen commonly used, commercially available, WC–12Co thermal spray powders were characterized in terms of their particle size distribution, surface morphology, cross-sectional morphology, and phase composition. Based on the results, four powders were selected for the deposition of thermal spray coatings using the JP 5000 high pressure high velocity oxyfuel (HPHVOF) system. Dry sand rubber wheel abrasion tests were performed on the coatings in order to determine the effect of powder manufacturing method on the wear rates. The coating produced using the cast and crushed powder did not deposit well and wore through very rapidly. The abrasion tests on the remaining coatings showed that the other two powder manufacturing routes are essentially equivalent in terms of the resultant coating wear resistance. PM/0777Keywords
This publication has 5 references indexed in Scilit:
- Formation of an amorphous phase in thermally sprayed WC-CoJournal of Thermal Spray Technology, 1996
- Effect of powder structure on the structure of thermally sprayed WC-Co coatingsJournal of Materials Science, 1996
- Microstructure and hydroabrasive wear behaviour of high velocity oxy-fuel thermally sprayed WCCo(Cr) coatingsSurface and Coatings Technology, 1993
- A pragmatic analysis and comparison of HVOF processesJournal of Thermal Spray Technology, 1992
- Microstructural evaluation of tungsten carbide-cobalt coatingsJournal of Thermal Spray Technology, 1992