High pressure steam–water two-phase flow measurements by flow division and separation method
Authors:
- 22 August 2012
- journal article
- Published by Elsevier in Experimental Thermal and Fluid Science
- Vol. 44, 468-474
Abstract
No abstract availableKeywords
This publication has 17 references indexed in Scilit:
- Steam flow measurement using alcohol tracersGeothermics, 2001
- A new method of two-phase flow measurement by orifice plate differential pressure noiseFlow Measurement and Instrumentation, 1995
- The use of critical flow venturi nozzles with saturated wet steamFlow Measurement and Instrumentation, 1995
- Measurement of mass flux in high temperature high pressure steam–water two-phase flow using a combination of Pitot tubes and a gamma densitometerNuclear Engineering and Design, 1990
- Wet steam flows in industrial large-diameter pipes: flowrate, moisture and pressure drop measurementsInternational Journal of Multiphase Flow, 1989
- Two-phase flow measurements with sharp-edged orificesInternational Journal of Multiphase Flow, 1982
- Measurements of two-phase mass flow rate: A comparison of different techniquesInternational Journal of Multiphase Flow, 1982
- Research Note: Pressure Drop during Steam/Water Flow through OrificesJournal of Mechanical Engineering Science, 1974
- Measurement of mass flow rates of water and steam in evaporator tubes on operating boilers using radiotracersThe International Journal of Applied Radiation and Isotopes, 1974
- Two-Phase Flow Measurement With OrificesJournal of Basic Engineering, 1962