The Influence of Welding Parameters on Tensile Behavior of Friction Stir Welded Al 2024-T4 Joints
Authors:
- 21 December 2009
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 83-86, 439-448
Abstract
In the present study, the relationships between friction stir welding parameters and the tensile behavior of Al 2024-T4 joints was investigated. The aluminum alloy plates were butt-welded using a hardened steel tool with a threaded and fluted cylindrical pin at various tool rotation speed to advancing speed ratios. Metallographic observations, EDS analysis and microhardness measurements show that the band spacing in the periodic microstructure of the stir zone and the average microhardness of this region decrease with increasing speed ratio. Tensile ductility is strongly affected by welding parameters and final elongation increases significantly with speed ratio at the constant rotating speed of 900 rpm. This behavior is found to be associated with a change in tensile fracture location. Formation of microscopic voids at low speed ratios leads to premature fracture in the nugget zone, while in the defect-free joints produced at higher speed ratios the fracture location shifts into the HAZ on the retreating side, which exhibits the lowest microhardness value within the weld joint. At the optimum rotation speed of 900 rpm and speed ratio of 11.2 rev/mm the tensile strength and final elongation of the joints are equivalent to 97% and 77% that of base metal, respectively.Keywords
This publication has 13 references indexed in Scilit:
- Analysis of local microstructure and hardness of 13 mm gauge 2024-T351 AA friction stir weldsMaterials Science and Technology, 2007
- Effect of welding parameters on tensile properties and fracture behavior of friction stir welded Al–Mg–Si alloyScripta Materialia, 2007
- On the coupling between precipitation and plastic deformation in relation with friction stir welding of AA2024 T3 aluminium alloyMaterials Science and Engineering: A, 2006
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Quantitative investigation of precipitation and mechanical behaviour for AA2024 friction stir weldsActa Materialia, 2005
- Correlation between microstructure and microhardness in a friction stir welded 2024 aluminium alloyScripta Materialia, 2005
- Banded microstructure in AA2024-T351 and AA2524-T351 aluminum friction stir weldsMaterials Science and Engineering: A, 2004
- Mixed mode I/II fracture of 2024-T3 friction stir weldsEngineering Fracture Mechanics, 2003
- Parameters controlling microstructure and hardness during friction-stir welding of precipitation-hardenable aluminum alloy 6063Metallurgical and Materials Transactions A, 2002
- Microstructural studies of friction stir welds in 2024-T3 aluminumMaterials Science and Engineering: A, 2002