Development of a test bench for biomechanical simulation—a preliminary study of mandibular forces
Authors:
Open Access
- 26 February 2024
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Bioengineering and Biotechnology
- Vol. 12, 1335159
Abstract
Purpose: The aim of this study is to develop a test bench, which integrates different complexity levels and enables in that way a flexible and dynamic testing for mid and long term intervals as well as testing of maximum loads till implant failure of different osteosynthesis systems on the mandible.Material and Methods: For this purpose, an analysis of the state of the art regarding existing test benches was combined with interviews of clinical experts to acquire a list of requirements. Based on these requirements a design for a modular test bench was developed. During the implementation of the test stand, functional tests were continuously carried out and improvements made. Depending on the level of complexity, the test bench can be used either as an incorporated variant or as a standalone solution. In order to verify the performance and the degree of fulfilment of the requirements of these two variants of the test bench, preliminary studies were carried out for all levels of complexity. In these preliminary studies, commercially available osteosynthesis and reconstruction plates were investigated for their biomechanical behaviour and compared with data from the literature.Results: In total, fourteen test runs were performed for the different levels of complexity. Firstly, five test runs were executed to test the simplified load scenario in the incorporated variant of the test bench. High forces could be transmitted without failure of the miniplates. Secondly a quasi-static test scenario was examined using the incorporated variant with simplified load insertion. Five experiments with a number of cycles between 40,896 and 100,000 cycles were carried out. In one case the quasi-static testing resulted in a fracture of the tested reconstruction plate with a failure mode similar to the clinical observations of failure. The last four test runs were carried out using the standalone variant of the test bench simulating complex load patterns via the insertion of forces through imitated muscles. During the test runs joint forces were measured and the amplitude and vector of the resulting joint forces were calculated for both temporomandibular joints. Differences in the force transmission depending on the implant system in comparison to the zero sample could be observed.Conclusion: The presented modular test bench showed to be applicable for examination of the biomechanical behavior of the mandible. It is characterized by the adjustability of the complexity regarding the load patterns and enables the subsequent integration of further sensor technologies. Follow-up studies are necessary to further qualify and optimize the test bench.Keywords
This publication has 34 references indexed in Scilit:
- MatrixMANDIBLE Preformed Reconstruction Plates—A Two-Year Two-Institution Experience in 71 PatientsJournal of Oral and Maxillofacial Surgery, 2012
- Treatment and complications of mandibular fractures: A 10-year analysisJournal of Cranio-Maxillofacial Surgery, 2012
- Reliability of electromyographic activity vs. bite-force from human masticatory musclesEuropean Journal of Oral Sciences, 2011
- Maximum voluntary molar bite force in subjects with normal occlusionEuropean Journal of Orthodontics, 2010
- Muscle and joint forces under variable equilibrium states of the mandibleClinical Oral Investigations, 2010
- Bite force and electromyograpy during maximum unilateral and bilateral clenchingEuropean Journal of Oral Sciences, 2008
- Biomechanical Testing of Different Osteosynthesis Systems for Segmental Resection of the MandibleJournal of Oral and Maxillofacial Surgery, 2007
- Fracture of titanium plates used for mandibular reconstruction following ablative tumor surgeryJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2006
- Biomechanics of the MandibleCritical Reviews in Oral Biology & Medicine, 2000
- Unilateral, isometric bite force in 8‐68‐year‐old women and men related to occlusal factorsEuropean Journal of Oral Sciences, 1990