Analysis and optimization of acoustic wave micro-resonators integrating piezoelectric zinc oxide layers
Authors:
- 17 February 2017
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 121 (7)
Abstract
This paper reports on the design, simulation, fabrication, and test results of ZnO-based contour-mode micro-resonators integrating piezoelectric zinc oxide (ZnO) layers. The inter-digitated (IDT) type micro-resonators are fabricated on ZnO films and suspended top of 2 μm thick silicon membranes using silicon-on insulator technology. We analyze several possibilities of increasing the quality factor (Q) and the electromechanical coupling coefficient (kt2) of the devices by varying the numbers and lengths of the IDT electrodes and using different thicknesses of the ZnO layer. We designed and fabricated IDTs of different finger numbers (n = 25, 40, 50, and 80) and lengths (L = 100/130/170/200 μm) for three different thicknesses of ZnO films (200, 600, and 800 nm). The measured Q factor confirms that reducing the length and the number of IDT fingers enables us to reach better electrical performances at resonant frequencies around 700 MHz. The extracted results for an optimized micro-resonator device having an IDT length of 100 μm and 40 finger electrodes show a Q of 1180 and a kt2 of 7.4%. We demonstrate also that the reduction of the ZnO thickness from 800 nm to 200 nm increases the quality factor from 430 to 1600, respectively, around 700 MHz. Experimental data are in very good agreement with theoretical simulations of the fabricated devicesKeywords
Funding Information
- XLIM
This publication has 20 references indexed in Scilit:
- A 2.8 GHz combined mode of vibration aluminum nitride MEMS resonator with high figure of merit exceeding 452013
- Nonlinearity reduction in silicon resonators by doping and re-orientation2013
- Micromachined sapphire GHz lateral overtone bulk acoustic resonators transduced by aluminum nitride2012
- A complete UMTS transmitter using BAW filters and duplexer: A 90-nm CMOS digital RF signal generator and a 0.25-μm BiCMOS power amplifierInternational Journal of RF and Microwave Computer-Aided Engineering, 2011
- A general procedure for the design of bulk acoustic wave filtersInternational Journal of RF and Microwave Computer-Aided Engineering, 2011
- Very high frequency channel-select MEMS filters based on self-coupled piezoelectric AlN contour-mode resonatorsSensors and Actuators A: Physical, 2010
- Bulk acoustic wave filters synthesis and optimization for multi-standard communication terminalsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2009
- Ultra Temperature-Stable Bulk-Acoustic-Wave Resonators with SiO 2 Compensation LayerIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2007
- Acoustic FBAR for filters, duplexers and front end modules2004
- Solidly mounted BAW filters for 8 GHz based on AlN thin films2004