Mechanical modeling of dowel action and the influence of small amounts of shear reinforcement on the shear‐transfer actions in RC beams
Open Access
- 14 May 2023
- journal article
- research article
- Published by Wiley in Structural Concrete
- Vol. 24 (5) , 5928-5946
Abstract
Dowel action of the longitudinal reinforcement in RC beams without and with small amounts of shear reinforcement is typically considered a constant shear contribution determined from the splitting strength of the concrete cover. However, in a recent experimental investigation by the authors, it was shown that the shear force transferred by dowel action for beams without shear reinforcement should be determined from the dowel displacement and a linear elastic model and a rigid plastic dowel model. This article is aimed at extending this model to also cover members with small amounts of shear reinforcement. To that aim, a novel approach to calculate the shear force carried by dowel action of the longitudinal reinforcement in both beams with and without shear reinforcement is presented. The model is derived by establishing an equilibrium of work between the internal stored elastic or dissipated plastic energy and the external work performed by the shear force in the dowel. Additionally, a method to determine the displacement of the dowel from DIC measurements is presented. For the remaining shear‐transfer actions, reasonable constitutive models from the literature are adapted. On the basis of DIC measurements, the shear force carried by each of the shear‐transfer actions is calculated for 16 shear tests of beams without and with small amounts of shear reinforcement. The sum of shear force carried by each of the shear‐transfer actions is shown to predict the applied shear force fairly well, from the development of the critical shear crack until failure. Additionally, it is shown that for beams with shear reinforcement below the minimum requirements according to the current design standards, the shear capacity is governed by aggregate interlock, residual tensile stresses, and the inclination of the compression chord. While for beams with shear reinforcement above the minimum requirements, the shear capacity is governed by the shear reinforcement and dowel action.Keywords
Funding Information
- Rambøll Fonden
This publication has 36 references indexed in Scilit:
- Analysis of shear-transfer actions on one-way RC members based on measured cracking pattern and failure kinematicsMagazine of Concrete Research, 2013
- Constitutive mixed mode model for cracks in concreteEngineering Fracture Mechanics, 2013
- Characterization of mixed mode crack opening in concreteMaterials and Structures, 2011
- Analytical Modeling of the Pre- and Postyield Behavior of Bond in Reinforced ConcreteJournal of Structural Engineering, 2007
- Tension Chord Model for Structural ConcreteStructural Engineering International, 1998
- Determination of fracture zone properties in mixed mode I and IIEngineering Fracture Mechanics, 1990
- BOND CHARACTERISTICS IN POST-YIELD RANGE OF DEFORMED BARSDoboku Gakkai Ronbunshu, 1987
- Aggregate Interlock Role in R.C. Thin‐Webbed Beams in ShearJournal of Structural Engineering, 1987
- Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elementsCement and Concrete Research, 1976
- Contribution of Longitudinal Steel to Shear Resistance of Reinforced Concrete BeamsACI Journal Proceedings, 1966