Plasma molding over surface topography: Energy and angular distribution of ions extracted out of large holes
Authors:
- 1 March 2002
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 91 (5) , 2594-2603
Abstract
Plasma molding over surface topography was investigated by measuring the energy and angular distribution of ions extracted from a hole in contact with a high density plasma. Holes with diameter larger than as well as smaller than the local sheath thickness were studied in argon or deuterium gas. When the hole diameter ~10 mm! was much less than the sheath thickness, the plasma was not perturbed by the presence of the hole. The ion energy distribution ~IED! had multiple peaks due to ions sampling the time-varying potential while crossing the sheath. The ion angular distribution ~IAD! was Gaussian, peaking at zero angle with respect to the surface normal. These results agree with reported studies. At the other extreme, when the hole diameter ~1270 mm! was larger than the sheath thickness, plasma ''leaked'' into the hole. The IED had a single peak since ions now experience an average sheath potential. The IAD was quite broad extending beyond 30° off normal. When the hole diameter ~508 mm! was comparable to the sheath thickness, the shape of the IED and IAD was in-between the two extremes mentioned above. The IAD became more isotropic with increasing power, suggesting that the plasma leaked only partly through the hole ~the plasma-sheath meniscus was located inside the hole!. For all cases, increasing pressure resulted in lower ion energy in argon plasmas due to ion-neutral collisions. Increasing pressure had little effect on the ion energy for deuterium plasmas, for hole diameter less than 508 mm. This is due to the smaller ion-neutral collision cross section for deuterium. © 2002 American Institute of Physics. @DOI: 10.1063/1.1435423#Keywords
This publication has 23 references indexed in Scilit:
- Incidence angle distributions of ions bombarding grounded surfaces in high density plasma reactorsMaterials Science in Semiconductor Processing, 1998
- Langmuir probe measurements in an inductively coupled plasma sourcePhysical Review E, 1997
- Ion energy and angular distributions in inductively coupled radio frequency discharges in argonJournal of Applied Physics, 1996
- Neutral Beam Source Design and Beam Kinetic Energy Activated SiO2 EtchingMRS Proceedings, 1992
- Plasma parameters of a radio frequency dischargeReview of Scientific Instruments, 1990
- A two-dimensional computer simulation for dry etching using Monte Carlo techniquesJournal of Applied Physics, 1989
- Ion and electron energy analysis at a surface in an RF dischargeJournal of Physics D: Applied Physics, 1988
- Construction of pierced hemispherical gridsJournal of Vacuum Science & Technology A, 1988
- An Energy Resolution Formula of a Three Plane Grids Retarding Field Energy AnalyzerJapanese Journal of Applied Physics, 1985
- Energy Dispersion of Positive Ions Effused from an RF PlasmaJournal of the Physical Society of Japan, 1970