A low power phase change memory using thermally confined TaN/TiN bottom electrode
Authors:
- 1 December 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01631918,p. 3.2.1-3.2.4
Abstract
Application of phase change memory (PCM) has been limited by the high power required to reset the device (changing from crystalline to amorphous state by melting the phase change material). Utilizing the poor thermal and electrical conductivity of TaN we have designed a simple structure that thermally insulates the bottom electrode and thus drastically reduces the heat loss. A 39nm bottom electrode with a TaN thermal barrier and 1.5nm of TiN conductor has demonstrated 30μA reset current, representing a 90% reduction. The benefit of thermal insulation is understood through electrothermal simulation, and the benefit is demonstrated in a 256Mb test chip. The low reset current also improves the reliability and excellent cycling endurance >;1E9 is observed. This low power device is promising for expanding the application for PCM.Keywords
This publication has 7 references indexed in Scilit:
- The impact of hole-induced electromigration on the cycling endurance of phase change memory2010
- High performance PRAM cell scalable to sub-20nm technology with below 4F2 cell size, extendable to DRAM applications2010
- A 45nm 1Gb 1.8V phase-change memory2010
- Confined-chalcogenide phase-change memory with thin metal oxide interlayer for low reset current operation2009
- Novel Lithography-Independent Pore Phase Change Memory2007
- Full Integration of Highly Manufacturable 512Mb PRAM based on 90nm Technology2006
- Highly Reliable 256Mb PRAM with Advanced Ring Contact Technology and Novel Encapsulating Technology2006