Effect of rotor slots parameters on synchronization capability of slotted solid rotor line start permanent magnet motor
Authors:
- 1 February 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 60-65
Abstract
Slotted solid rotor line-start permanent magnet motor has good synchronization capability in high load torque and high moment of inertia. This paper analysis the rotor slots parameters effect on the motor performance. These parameters are rotor slot length and width. For these, two important torques were considered. Starting torque and the torque near synchronization speed. For high synchronization capability these torques should be in high value. Result of sensitivity analysis shows, the rotor slot depth and width of 16.8 mm, and 2 mm, respectively was considered in case study motor design. At the end, a 4-pole, 1500 rpm, 750 watt, 3-phase line start synchronous motor with optimized slotted solid rotor is built.Keywords
This publication has 9 references indexed in Scilit:
- Line-Start Permanent-Magnet Motors: Significant Improvements in Starting Torque, Synchronization, and Steady-State PerformanceIEEE Transactions on Magnetics, 2010
- Line start permanent magnet synchronous motors: Challenges and opportunitiesEnergy, 2009
- A High-Performance Line-Start Permanent Magnet Synchronous Motor Amended From a Small Industrial Three-Phase Induction MotorIEEE Transactions on Magnetics, 2009
- High-Speed High-Output Solid-Rotor Induction-Motor Technology for Gas CompressionIEEE Transactions on Industrial Electronics, 2009
- Design and Analysis of Different Line-Start PM Synchronous Motors for Oil-Pump ApplicationsIEEE Transactions on Magnetics, 2009
- Analysis of a Three-Phase LSPMM by Numerical MethodIEEE Transactions on Magnetics, 2009
- A Study on the Optimal Rotor Design of LSPM Considering the Starting Torque and EfficiencyIEEE Transactions on Magnetics, 2009
- Line-Starting Three- and Single-Phase Interior Permanent Magnet Synchronous Motors—Direct Comparison to Induction MotorsIEEE Transactions on Magnetics, 2008
- Design of Line Start PM Motors with High Power Factor2007