Strength differential effect in SiCpreinforced Al composites
Authors:
- V. K. VarmaVVV. K. Varma
- S. V. KamatSKS. V. Kamat
- Y. R. MahajanYMY. R. Mahajan
- V. V. KutumbaraoVKV. V. Kutumbarao
- V. K. Varma1∗, S. V. Kamat1, Y. R. Mahajan2, V. V. Kutumbarao31 Defence Metallurgical Research Laboratory, Kanchanbagh, Hyderabad, India2 International Advanced Research Centre, Balapur, Hyderabad, India3 Jawaharlal Nehru Aluminium Research Development anVAV. K. Varma1∗, S. V. Kamat1, Y. R. Mahajan2, V. V. Kutumbarao31 Defence Metallurgical Research Laboratory, Kanchanbagh, Hyderabad, India2 International Advanced Research Centre, Balapur, Hyderabad, India3 Jawaharlal Nehru Aluminium Research Development an
- Mumin SahinMSMumin Sahin
- Can GulerCGCan Guler
- Cenk MisirliCMCenk Misirli
- Cem S. CetinarslanCCCem S. Cetinarslan
- Hamid EisazadehHEHamid Eisazadeh
- 1 September 2002
- journal article
- Published by Walter de Gruyter GmbH in Zeitschrift für Metallkunde
- Vol. 93 (9) , 910-912
Abstract
The strength differential (SD) effect as a function of plastic strain in SiCP reinforced Al–Cu–Mg alloy matrix composites with varying reinforcement sizes was investigated. Matrix alloy was also produced in a similar manner for comparison and designated as Control. All the materials exhibited significantly negative SD at very low plastic strains. The magnitude of the negative SD decreased and eventually became positive with increasing plastic strain. All the metal matrix composites exhibited a higher negative SD below and a higher positive SD above 0.35% plastic strain as compared to Control. The observed results were attributed to the nature, magnitude and distribution of thermal residual stresses in the matrix of MMCs and work hardening during deformation.Keywords
This publication has 14 references indexed in Scilit:
- Finite element modelling of residual stresses and strength differential effect in discontinuously reinforced metal matrix compositesMaterials Science and Engineering: A, 1994
- Low strain plasticity in a particulate metal matrix compositeActa Metallurgica et Materialia, 1994
- Effects of misfit strain and reverse loading on the flow strength of particulate-reinforced A1 matrix compositesActa Metallurgica et Materialia, 1992
- Elastoplastic finite element analysis of short-fiber-reinforced SiC/Al composites: effects of thermal treatmentActa Metallurgica et Materialia, 1991
- A study of the microplasticity of some discontinuously reinforced metal matrix compositesScripta Metallurgica et Materialia, 1990
- The strength differential and Bauschinger effects in SiCAl compositesMaterials Science and Engineering, 1987
- Internal strain (stress) in an SiCAl particle-reinforced composite: an X-ray diffraction studyMaterials Science and Engineering, 1987
- Thermal residual stress in metal matrix compositeActa Metallurgica, 1987
- Deformation in Al-z.sbnd;SiC composites due to thermal stressesMaterials Science and Engineering, 1985
- Effect of martensite morphology on the strength differential effect in dual phase steelsScripta Metallurgica, 1984