MEMS reconfigurable millimeter-wave surface for V-band rectangular-waveguide switch
- 23 April 2013
- journal article
- research article
- Published by Cambridge University Press (CUP) in International Journal of Microwave and Wireless Technologies
- Vol. 5 (3) , 341-349
Abstract
This paper presents for the first time a novel concept of a microelectromechanical systems (MEMS) waveguide switch based on a reconfigurable surface, whose working principle is to block the wave propagation by short-circuiting the electrical field lines of the TE10 mode of a WR-12 rectangular waveguide. The reconfigurable surface is only 30 µm thick and consists of up to 1260 micromachined cantilevers and 660 contact points in the waveguide cross-section, which are moved simultaneously by integrated MEMS comb-drive actuators. Measurements of fabricated prototypes show that the devices are blocking wave propagation in the OFF-state with over 30 dB isolation for all designs, and allow for transmission of less than 0.65 dB insertion loss for the best design in the ON-state for 60–70 GHz. Furthermore, the paper investigates the integration of such microchips into WR-12 waveguides, which is facilitated by tailor-made waveguide flanges and compliant, conductive-polymer interposer sheets. It is demonstrated by reference measurements where the measured insertion loss of the switches is mainly attributed to the chip-to-waveguide assembly. For the first prototypes of this novel MEMS microwave device concept, the comb-drive actuators did not function properly due to poor fabrication yield. Therefore, for measuring the OFF-state, the devices were fixated mechanically.Keywords
This publication has 21 references indexed in Scilit:
- Active Opening Force and Passive Contact Force Electrostatic Switches for Soft Metal Contact MaterialsJournal of Microelectromechanical Systems, 2006
- Extending displacements of comb drive actuators by adding secondary comb electrodesJournal of Micromechanics and Microengineering, 2006
- RF MEMS Waveguide SwitchIEEE Transactions on Microwave Theory and Techniques, 2004
- Low-loss lateral micromachined switches for high frequency applicationsJournal of Micromechanics and Microengineering, 2004
- Microelectromechanical capacitors for RF applicationsJournal of Micromechanics and Microengineering, 2002
- RF MEMS switches and switch circuitsIEEE Microwave Magazine, 2001
- A new micromachined overlay CPW structure with low attenuation over wide impedance ranges and its application to low-pass filtersIEEE Transactions on Microwave Theory and Techniques, 2001
- RF MEMS from a device perspectiveJournal of Micromechanics and Microengineering, 2000
- Si-micromachined coplanar waveguides for use in high-frequency circuitsIEEE Transactions on Microwave Theory and Techniques, 1998
- Comb-drive actuators for large displacementsJournal of Micromechanics and Microengineering, 1996