Cryogenic Electrical Characterization and Equivalent-Circuit Modeling of SAW Resonators
Authors:
- 1 May 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
A surface acoustic wave resonator (SAW) was characterized by means of scattering (S-) parameters, recorded over the wide temperature range spanning from 300 K down to 20 K with a step of 10 K. The frequency- and temperature-dependent behavior was investigated and the experimental data were employed to extract equivalent circuit models able to represent the device close to the values of the observed resonant frequencies. The experimental activity is performed with the two-fold purpose of assessing the temperature sensing properties of the studied SAW, even down to cryogenic temperatures, and of enabling the design of low noise oscillators.Keywords
This publication has 14 references indexed in Scilit:
- Celestial Signals: Are Low-Noise Amplifiers the Future for Millimeter-Wave Radio Astronomy Receivers?IEEE Microwave Magazine, 2017
- Design of Miniaturized HTS Dual-Band Bandpass Filters Using Stub-Loaded Meander Line Resonators and Their Applications to Tri-Band Bandpass FiltersIEEE Transactions on Applied Superconductivity, 2014
- Microwave noise properties of heterojunction bipolar transistors2014
- Surface Acoustic Wave Pulsed-Correlator Transceiver for Aerospace ApplicationsIEEE Sensors Journal, 2014
- Passive Wireless Sensor Applications for NASA’s Extreme Aeronautical EnvironmentsIEEE Sensors Journal, 2014
- Surface acoustic wave (SAW) devices2012
- Development of a SOLT Calibration Setup for SAW Sensor Characterization2011
- Cryogenic transistor measurement and modeling for engineering applicationsCryogenics, 2010
- Cryogenic Liquid Sensing Using SAW Devices2007 IEEE International Frequency Control Symposium Joint with the 21st European Frequency and Time Forum, 2007
- Microwave Characterization and Modeling of Packaged HEMTs by a Direct Extraction Procedure Down to 30 KIEEE Transactions on Instrumentation and Measurement, 2006