Comparative analysis of copper and graphite electrodes in EDM of Al–SiC metal matrix composites
Open Access
- 30 January 2026
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Abstract
This study presents a comprehensive investigation of electrical discharge machining (EDM) applied to Al-SiC metal matrix composites (MMCs), focusing on the comparative performance of copper and graphite tool electrodes. Material removal rate (MRR) and tool wear rate (TWR) were considered as the primary response variables, while current, pulse-on time (TON), and pulse-off time (TOFF) served as the controlling parameters. A Box–Behnken experimental design was employed to construct the design matrix, and analysis of variance (ANOVA) was used to evaluate the statistical significance of the process variables. Results indicate that both current and TON exert a strong influence on MRR and TWR, whereas increasing TOFF consistently reduces TWR for both electrodes. Overall, copper electrodes demonstrated superior machinability, offering up to 18% higher MRR and 25% lower TWR compared to graphite. These findings establish copper as a more efficient tool material for EDM of Al–SiC MMCs and provide practical guidelines for optimizing EDM parameters to enhance productivity and reduce tool wear in composite machining applications.Keywords
This publication has 51 references indexed in Scilit:
- Stir Cast Al–Cu–SiCp Metal Matrix Composites: Effect of SiC Particles on the Mechanical Properties and Optimization of EDM Process ParametersJournal of The Institution of Engineers (India): Series D, 2022
- Machinability of Nimonic Alloy 90 in µ-Titanium Carbide Mixed Electrical Discharge MachiningArabian Journal for Science and Engineering, 2022
- Parametric Analysis of Electric Discharge Machining of Hybrid Composite Materials2021
- Sustainable Electrical Discharge Machining of Nimonic C263 SuperalloyArabian Journal for Science and Engineering, 2021
- Multi-objective optimization of some correlated process parameters in EDM of Inconel 800 using a hybrid approachJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2019
- Tribological characterisation in dry sliding conditions of compocasted hybrid A356/SiCp/Grp composites with graphite macroparticlesThe International Journal of Advanced Manufacturing Technology, 2018
- Optimization of material removal rate and tool wear rate of Cu electrode in die-sinking EDM of tool steelThe International Journal of Advanced Manufacturing Technology, 2018
- Investigating the electrical discharge machining (EDM) parameter effects on Al-Mg2Si metal matrix composite (MMC) for high material removal rate (MRR) and less EWR–RSM approachThe International Journal of Advanced Manufacturing Technology, 2014
- Effect of Current in the EDM Machining of Aluminum 6061 T6 and its Effect on the Surface MorphologyArabian Journal for Science and Engineering, 2014
- Aluminium matrix composites: Challenges and opportunitiesSādhanā, 2003