The effect of constant height bracket placement on marginal ridge levelling using digitized models
Authors:
Open Access
- 1 June 2009
- journal article
- research article
- Published by Oxford University Press (OUP) in European Journal of Orthodontics
- Vol. 32 (1) , 100-105
Abstract
Bracket placement is an important phase of orthodontic treatment. Final compensatory archwire bends or bracket repositioning may be avoided if brackets are accurately positioned at the outset, so as to correctly express their built-in prescription. The purpose of this study was to investigate the levelling of marginal ridges when a bracket placement protocol, with fixed values from the incisal edges and occlusal surfaces, was used on digitized models. A computerized tool, OrthoCAD®, was used to predict the end result using virtual set-up software. The appliances used for digital simulation were 3M MBT Victory Series 0.022 inch with a 0.019 × 0.025 inch stainless steel final archwire on 42 digitized models. A paired t-test was used to investigate differences between the means of the pre- (T1) and post- (T2) treatment marginal ridge heights. The results showed that most of the marginal ridge points studied deteriorated during digitized treatment prediction compared with T1. Statistical and clinically significant changes (P < 0.05) were found for upper premolar and lower molar marginal ridge points. Variability in the facial contour of the teeth seemed to play an important role.Keywords
This publication has 15 references indexed in Scilit:
- Evaluation of a software program for applying the American Board of Orthodontics objective grading system to digital castsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2008
- A comparison of accuracy in bracket positioning between two techniques--localizing the centre of the clinical crown and measuring the distance from the incisal edgeEuropean Journal of Orthodontics, 2007
- Choosing a pre-adjusted orthodontic appliance prescription for anterior teethJournal of Orthodontics, 2007
- Evaluation of the accuracy of digital model analysis for the American Board of Orthodontics objective grading system for dental castsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2005
- A new way of analyzing occlusion 3 dimensionallyAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2005
- Comparison of measurements made on digital and plaster modelsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2003
- Objective grading system for dental casts and panoramic radiographsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1998
- Three-dimensional dental cast analyzing system using laser scanningAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1996
- Straight wire: The next generationAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1993
- Three biologic variables modifying faciolingual tooth angulation by straight-wire appliancesAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1989