Advances in Manufacturing of Molded Tips for Scanning Probe Microscopy
- 2 December 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 21 (2) , 431-442
Abstract
A common method for producing sharp tips used in scanning probe microscopy (SPM) and other applications involving nanoscale tips is to deposit thin-film materials, such as metals, silicon nitride, or diamond-based films, into four-faceted pyramidal molds that are formed by anisotropic etching into a (100) silicon substrate. This well-established method is capable of producing tips with radii as small as a few nanometers. However, the shape of the tip apex is difficult to control with this method, and wedge-shaped tips that are elongated in one dimension are often obtained. This limitation arises due to the practical difficulty of having four planes intersecting at a single point. Here, a new method for producing three-sided molds for SPM tips is demonstrated through the use of etching in (311) silicon wafers. It is shown that silicon nitride and ultrananocrystalline diamond tips fabricated with this new method are wedge free and sharp (<; 10 nm radius), thereby restoring tip molding as a well-controlled manufacturing process for producing ultrasharp SPM tips.Keywords
This publication has 21 references indexed in Scilit:
- Preventing Nanoscale Wear of Atomic Force Microscopy Tips Through the Use of Monolithic Ultrananocrystalline Diamond ProbesSmall, 2010
- Wear characteristics of diamond-coated atomic force microscope probeUltramicroscopy, 2007
- Microfabrication and application of high-aspect-ratio silicon tipsJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2005
- Fabrication and characterization of full diamond tips for scanning spreading-resistance microscopyMicroelectronic Engineering, 2004
- Sequence-dependent mechanics of single DNA moleculesNature Structural & Molecular Biology, 1999
- Simultaneous force and conduction measurements in atomic force microscopyPhysical Review B, 1997
- Characterization of the microstructure of diamond pyramidal microtip emittersDiamond and Related Materials, 1997
- Cantilevers and tips for atomic force microscopyIEEE Engineering in Medicine and Biology Magazine, 1997
- Two-dimensional thermal oxidation of silicon. II. Modeling stress effects in wet oxidesIEEE Transactions on Electron Devices, 1988
- A Water-Amine-Complexing Agent System for Etching SiliconJournal of the Electrochemical Society, 1967