An on-line method for stator fault detection in multi-phase PMSM drives
Authors:
- 1 September 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19388756,p. 1-6
Abstract
This paper deals with an on-line fault detection method for multi-phase PMSM drives. The method is based on the detection of the stator current positive- and negative sequence fundamental components expressed in the stationary αβ reference frame. These components allow calculating a fault index used for the detection of stator faults, such as open-circuit faults. The decision criterion is based on the CUSUM algorithm. A model of a five-phase machine with one single-phase open-circuit is derived and validated with experimental results. Then, it is shown that the proposed method achieves fault detection on a wide speed range and even during speed transient.Keywords
This publication has 16 references indexed in Scilit:
- Sensor and open-phase fault detection and isolation for three-phase AC drives2010
- Generation of on-line optimal current references for Multi-phase Permanent Magnet Machines with open-circuited phases2009
- Open-circuit fault tolerant control of five-phase permanent magnet motors with third-harmonic back-EMF2008
- Advances in Diagnostic Techniques for Induction MachinesIEEE Transactions on Industrial Electronics, 2008
- A Survey of Methods for Detection of Stator-Related Faults in Induction MachinesIEEE Transactions on Industry Applications, 2007
- Strategies for the Fault-Tolerant Current Control of a Five-Phase Permanent-Magnet MotorIEEE Transactions on Industry Applications, 2007
- Comparison of two 5-phase Permanent Magnet machine winding configurations. Application on naval propulsion specifications.2007
- New positive-sequence voltage detector for grid synchronization of power converters under faulty grid conditions2006
- Condition Monitoring and Fault Diagnosis of Electrical Motors—A ReviewIEEE Transactions on Energy Conversion, 2005
- A review of induction motors signature analysis as a medium for faults detectionIEEE Transactions on Industrial Electronics, 2000