Interaction of Load and Residual Stresses in Sintered 1.3344 High Speed Steel
Authors:
- 12 September 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 1018, 145-152
Abstract
Compressive residual stresses enhance cold forging tool lifetime. These stresses can be induced during the grinding process of the tool manufacturing. To use residual stresses induced by grinding it must be understood how load and residual stresses interact in ground and unground sub-surface zones. This has been studied with specimen from powder metallurgically produced 1.3344 high-speed steel. Residual stresses in the specimen where measured through x-ray diffraction in ground and unground conditions and under various applied load stresses. Residual stresses and load stresses sum up directly proportional at lower stresses, while at higher stresses a saturated stress state is achieved and the whole material deforms plastically.Keywords
This publication has 12 references indexed in Scilit:
- Correlations between nanoindentation hardness and macroscopic mechanical properties in DP980 steelsMaterials Science and Engineering: A, 2014
- Sheet-Bulk Metal Forming of Symmetric and Asymmetric PartsAdvanced Materials Research, 2013
- Investigations on Orbital Forming of Sheet Metals to Manufacture Tailored Blanks with a Defined Sheet Thickness VariationAdvanced Materials Research, 2013
- In situ measurement of lattice strains in mixed ceramic cutting tools under thermal and mechanical loads using synchrotron radiationProduction Engineering, 2012
- Fundamental investigations on the material flow at combined sheet and bulk metal forming processesCIRP Annals, 2011
- Influence of machining process on residual stresses in the surface of cemented carbidesProcedia Engineering, 2011
- Prediction of contact conditions and theoretical roughness in manufacturing of complex implants by toric grinding toolsInternational Journal of Machine Tools and Manufacture, 2010
- Machining induced residual stress in structural aluminum partsProduction Engineering, 2008
- Fließpressen2008
- A simple method of eliminating residual tensile stresses in the grinding of low carbon steelsInternational Journal of Machine Tools and Manufacture, 1991