Investigation on Stress Relaxation Behavior in Cu-Ni-Sn-P Alloys
Authors:
- F. NishijimaFNF. Nishijima
- K. NomuraKNK. Nomura
- C. WatanabeCWC. Watanabe
- R. MonzenRMR. Monzen
- 1 January 2008
- journal article
- Published by Japan Institute of Metals in Journal of the Japan Institute of Metals and Materials
- Vol. 72 (6) , 427-432
Abstract
The effects of alloying elements on the stress relaxation property of Cu-Ni-Sn-P alloys have been investigated using Cu, Cu-1.5 at% (1.4 mass%) Ni alloys, Cu-0.75 at% (0.7 mass%) Ni-0.75 at% (1.4 mass%) Sn alloys and Cu-1.5 at% (2.8 mass%) Sn alloys with and without 0.14 at% (0.07 mass%) P. Adding Sn to Cu enhances the resistance to stress relaxation by dragging atmospheres of Sn atoms behind dislocations. The Cu-Ni-P alloy exhibits better stress relaxation property than the Cu-Ni and Cu-P alloys, probably because atoms caused by pairs of P and Ni chemical binding are dragged by moving dislocations. Annealing of the Cu alloys with P at a low temperature of 300°C for a short time brings about higher stress-relaxation resistance. This is ascribed to the decrease in mobile dislocation density by segregation of P atoms on dislocations during the annealing. Adding 0.1 at% (0.04 mass%) Mg to the Cu-Ni-Sn-P alloy decreases the amounts of Ni and P dissolved in the Cu matrix, resulting in lower stress-relaxation resistance. The addition of 0.1 at% (0.09 mass%) Fe to the Cu-Ni-Sn-P alloy is effective for the improvement of stress relaxation property.Keywords
This publication has 8 references indexed in Scilit:
- On the crystallization kinetics and micro-structural transformations of Fe40Ni38B18Mo4 alloysJournal of Materials Science, 2007
- Development of a high-strength high-conductivity Cu-Ni-P alloy. Part I: Characterization of precipitation productsJournal of Electronic Materials, 2006
- Categorization of ambient temperature creep behavior of metals and alloys on their crystallographic structuresJournal of Japan Institute of Light Metals, 2005
- Stress Relaxation Resistance of Cu-1Ni-0.9Sn-0.05P Alloy(C19025).Materia Japan, 1998
- Stage IV work hardening in cell forming materials, part I: Features of the dislocation structure determined by X-ray line broadeningScripta Materialia, 1996
- Development of High-resistance Stress Relaxation Cu-Ni-Sn Alloy.Bulletin of the Japan Institute of Metals, 1993
- Glide and climb resistance to the motion of an edge dislocation due to dragging a Cottrell atmospherePhilosophical Magazine A, 1979
- New Yielding Phenomenon Observed in Some Aluminium Alloys at High TemperaturesJournal of the Japan Institute of Metals and Materials, 1965