Atmospheric CO2 capture for the artificial photosynthetic system
Open Access
- 7 November 2017
- conference paper
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 22, 00125
Abstract
The scope of these studies is to evaluate the ambient CO2 capture abilities of the membrane contactor system in the same conditions as leaves works during photosynthesis, such as ambient temperature, pressure and low CO2 concentration, where the only driving force is the concentration gradient. The polysulfone membrane was made by phase inversion process and characterized by ESEM micrographs which were used to determine the thickness, asymmetry and pore size. Besides, the porosity of the membrane was measured from the membrane and polysulfone density correlation and hydrophobicity was analyzed by contact angle measurements. Moreover, the compatibility of the membrane and absorbent solution was evaluated, in order to exclude wetting issues. The prepared membranes were introduced in a cross flow module and used as contactor between the CO2 and the potassium hydroxide solution, as absorbing media. The influence of the membrane thickness, absorbent stirring rate and absorption time, on CO2 capture were evaluated. The results show that the efficiency of our CO2 capture system is similar to stomatal carbon dioxide assimilation rate.Keywords
This publication has 12 references indexed in Scilit:
- Climate change conditions (elevated CO2 and temperature) and UV-B radiation affect grapevine (Vitis vinifera cv. Tempranillo) leaf carbon assimilation, altering fruit ripening ratesPlant Science, 2015
- Regulatory effects of exogenous gibberellic acid (GA3) on water relations and CO2 assimilation among grapevine (Vitis vinifera L.) cultivarsScientia Horticulturae, 2013
- Trends in the sources and sinks of carbon dioxideNature Geoscience, 2009
- Contributions to accelerating atmospheric CO 2 growth from economic activity, carbon intensity, and efficiency of natural sinksProceedings of the National Academy of Sciences, 2007
- Membrane–solvent selection for CO2 removal using membrane gas–liquid contactorsSeparation and Purification Technology, 2004
- Gas solubility, diffusivity and permeability in poly(ethylene oxide)Journal of Membrane Science, 2004
- Quantification of membrane morphology by interpretation of scanning electron microscopy imagesJournal of Membrane Science, 2004
- CO2 separation with polyolefin membrane contactors and dedicated absorption liquids: performances and prospectsSeparation and Purification Technology, 2002
- Preparation and characterisation of polyaniline based membranes for gas separationJournal of Membrane Science, 2001
- Polymers for gas separations: the next decadeJournal of Membrane Science, 1994