Effect of the notch location on the Charpy-V toughness results for robotic flux-cored arc welded multipass joints
- 1 September 2022
- journal article
- research article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 64 (9) , 1278-1289
Abstract
In this study, the effect of the notch locations on the Charpy-V toughness values of the all-welded joint obtained using robotic flux-cored arc welding was investigated with respect to microstructures at the notch locations. Charpy impact tests were performed through the thickness with notch location at the centerline as well as off-set regions of the weld metal in addition to the microhardness measurements conducted. The detailed weld metal characterization was conducted using a stereo microscope, optical microscope, and scanning electron microscope at the same location where the Charpy tests and microhardness tests were performed. The sub-zero impact toughness test results indicated that the columnar weld metal regions exhibited low toughness values while the centerline microstructure consisting of mainly reheated regions displayed much higher toughness values even at the test temperature of −60 °C, satisfying the toughness requirement of the requested 47 J value. It is concluded that a small variation of the through-thickness notch position may result in different toughness values for the same weld metal. On this basis, the notching procedure of the Charpy-V samples for the multi-pass weld metal should be conducted with care and obtained results should be explained with respective notch position and microstructure.Keywords
This publication has 34 references indexed in Scilit:
- Effect of microstructural heterogeneities on scatter of toughness in multi-pass weld metal of C–Mn steelsScience and Technology of Welding and Joining, 2014
- Cleavage Fracture Initiation at M–A Constituents in Intercritically Coarse-Grained Heat-Affected Zone of a HSLA SteelMetallurgical and Materials Transactions A, 2013
- Shielding gas effects on flux cored arc welding of AISI 316L (N) austenitic stainless steel jointsMaterials & Design (1980-2015), 2013
- Microstructural studies and impact toughness of dissimilar weldments between AISI 316 L and AH36 steels by FCAWThe International Journal of Advanced Manufacturing Technology, 2012
- Flux cored arc welding2006
- Effect of shielding gas mixture on gas metal arc welding of HSLA steel using solid and flux-cored wiresThe International Journal of Advanced Manufacturing Technology, 2005
- Normalizing heat treatment effect on low alloy steel weld metalsJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2004
- The effect of chromium on the microstructure/toughness relationship of C–Mn weld metal depositsMaterials Characterization, 2001
- Columnar grain development in C-Mn-Ni low-alloy weld metals and the influence of nickelJournal of Materials Science, 1995
- Acicular ferrite in carbon-manganese weld metals: An overviewJournal of Materials Science, 1987