A Systematic Computational Methodology Applied to a Three-Dimensional Film-Cooling Flowfield
Authors:
- 1 October 1997
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 119 (4) , 777-785
Abstract
Numerical results are presented for a three-dimensional discrete-jet in crossflow problem typical of a realistic film-cooling application in gas turbines. Key aspects of the study include: (1) application of a systematic computational methodology that stresses accurate computational model of the physical problem, including simultaneous, fully elliptic solution of the crossflow, film-hole, and plenum regions; high-quality three-dimensional unstructured grid generation techniques, which have yet to be documented for this class of problems; the use of a high-order discretization scheme to reduce numerical errors significantly; and effective turbulence modeling; (2) a three-way comparison of results to both code validation quality experimental data and a previously documented structured grid simulation; and (3) identification of sources of discrepancy between predicted and measured results, as well as recommendations to alleviate these discrepancies. Solutions were obtained with a multiblock, unstructured/adaptive grid, fully explicit, time-marching, Reynolds-averaged Navier–Stokes code with multigrid, local time stepping, and residual smoothing type acceleration techniques. The computational methodology was applied to the validation test case of a row of discrete jets on a flat plate with a streamwise injection angle of 35 deg, and two film-hole length-to-diameter ratios of 3.5 and 1.75. The density ratio for all cases was 2.0, blowing ratio was varied from 0.5 to 2.0, and free-stream turbulence intensity was 2 percent. The results demonstrate that the prescribed computational methodology yields consistently more accurate solutions for this class of problems than previous attempts published in the open literature. Sources of disagreement between measured and computed results have been identified, and recommendations made for future prediction of film-cooling problems.Keywords
This publication has 15 references indexed in Scilit:
- Discrete-Jet Film Cooling: A Comparison of Computational Results With ExperimentsJournal of Turbomachinery, 1994
- Film-Cooling Effectiveness Downstream of a Single Row of Holes With Variable Density RatioJournal of Turbomachinery, 1991
- The development of a solution-adaptive 3D Navier-Stokes solver for turbomachinery1991
- Effects of Density Ratio on the Hydrodynamics of Film CoolingJournal of Turbomachinery, 1990
- Characteristic-Based Schemes for the Euler EquationsAnnual Review of Fluid Mechanics, 1986
- A stable and accurate convective modelling procedure based on quadratic upstream interpolationComputer Methods in Applied Mechanics and Engineering, 1979
- THE TURBULENT JET IN A CROSS STREAM AT LOW INJECTION RATES: A THREE-DIMENSIONAL NUMERICAL TREATMENTNumerical Heat Transfer, 1978
- Near-field character of a jet discharged through a wall at 30 deg toa mainstreamAIAA Journal, 1977
- The Near-Field Character of a Jet Discharged Normal to a Main StreamJournal of Heat Transfer, 1976
- The numerical computation of turbulent flowsComputer Methods in Applied Mechanics and Engineering, 1974