Clinical utility of pressure feedback to socket design and fabrication
- 1 February 2020
- journal article
- research article
- Published by Wolters Kluwer Health in Prosthetics and Orthotics International
- Vol. 44 (1) , 18-26
Abstract
Urements between sockets made by different clinicians, and a reduction in pressure over areas of concern. It also investigated whether clinicians value knowing the interface pressure during the fabrication process. Study design: Mixed methods. Methods: Three prosthetists designed a complete prosthetic system for a transtibial residual limb surrogate. Standardised mechanical testing was performed on each prosthetic system to gain pressure measurements at four key anatomical locations. These measurements were provided to the clinicians, who subsequently modified their sockets as each saw fit. The pressure at each location was re-measured. Each prosthetist completed a survey that evaluated the usefulness of knowing interface pressures during the fabrication process. Results: Feedback and subsequent socket modifications saw a reduction in the pressure measurements at three of the four anatomical locations. Furthermore, the pressure measurements between prosthetists converged. All three prosthetists found value in the pressure measurement system and felt they would use it clinically. Conclusions: Results suggest that sensors measuring pressure at the socket-limb interface has clinical utility in the context of informing prosthetic socket design and fabrication. If the technology is used at the check socket stage, iterative designs with repeated measurements can result in increased consistency between clinicians for the same residual limb, and reductions in the magnitudes of pressures over specific anatomical landmarks. Clinical relevance This study provides new information on the value of pressure feedback to the prosthetic socket design process. It shows that with feedback, socket modifications can result in reduced limb pressures, and more consistent pressure distributions between prosthetists. It also justifies the use of pressure feedback in informing clinical decisions....Keywords
Funding Information
- International Society for Prosthetics and Orthotics (2017 Australian National Member Society Encouragem)
This publication has 30 references indexed in Scilit:
- Marker-based method to measure movement between the residual limb and a transtibial prosthetic socketProsthetics and Orthotics International, 2016
- Interface Stress in Socket/Residual Limb with Transtibial Prosthetic Suspension Systems During Locomotion on Slopes and StairsAmerican Journal of Physical Medicine & Rehabilitation, 2015
- Interface pressure in transtibial socket during ascent and descent on stairs and its effect on patient satisfactionClinical Biomechanics, 2013
- Hands‐Off and Hands‐On Casting Consistency of Amputee below Knee Sockets Using Magnetic Resonance ImagingThe Scientific World Journal, 2013
- An experimental study of the interface pressure profile during level walking of a new suspension system for lower limb amputeesClinical Biomechanics, 2013
- Skin Problems of the Stump in Lower-limb Amputees: 2. Influence on Functioning in Daily LifeActa Dermato-Venereologica, 2011
- Skin Problems of the Stump in Lower Limb Amputees: 1. A Clinical StudyActa Dermato-Venereologica, 2011
- Skin problems in lower limb amputees: A systematic reviewDisability and Rehabilitation, 2006
- Changes in interface pressures and shear stresses over time on trans-tibial amputee subjects ambulating with prosthetic limbs: comparison of diurnal and six-month differencesJournal of Biomechanics, 2005
- Regional differences in pain threshold and tolerance of the transtibial residual limb: Including the effects of age and interface materialArchives of Physical Medicine and Rehabilitation, 2005