Blood flow in small tubes: quantifying the transition to the non-continuum regime
- 28 March 2013
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 722, 214-239
Abstract
In small vessels blood is usually treated as a Newtonian fluid down to diameters of ${\sim }200~\mathrm{\mu} \mathrm{m} $ . We investigate the flow of red blood cell (RBC) suspensions driven through small tubes (diameters $10\text{{\ndash}} 150~\mathrm{\mu} \mathrm{m} $ ) in the range marking the transition from arterioles and venules to the largest capillary vessels. The results of the simulations combined with previous simulations of uniform shear flow and experimental data show that for diameters less than ${\sim }100~\mathrm{\mu} \mathrm{m} $ the suspension’s stress cannot be described as a continuum, even a heterogeneous one. We employ the dissipative particle dynamics (DPD) model, which has been successfully used to predict human blood bulk viscosity in homogeneous shear flow (Fedosovet al. Proc. Natl Acad. Sci. USA, vol. 108, 2011, pp. 11772–11777). In tube flow the cross-stream stress gradient induces an inhomogeneous distribution of RBCs featuring a centreline cell density peak, and a cell-free layer (CFL) next to the wall. For a neutrally buoyant suspension the imposed linear shear-stress distribution together with the differentiable velocity distribution allow the calculation of the local viscosity across the tube section. The viscosity across the section as a function of the strain rate is found to be essentially independent of tube size for the larger diameters and is determined by the local haematocrit ( $H$ ) and shear rate. Other RBC properties such as asphericity, deformation, and cell-flow orientation exhibit similar dependence for the larger tube diameters. As the tube size decreases below ${\sim }100~\mathrm{\mu} \mathrm{m} $ in diameter, the viscosity in the central region departs from the large-tube similarity function of the shear rate, since $H$ increases significantly towards the centreline. The dependence of shear stress on tube size, in addition to the expected local shear rate and local haematocrit, implies that blood flow in small tubes cannot be described as a heterogeneous continuum. Based on the analysis of the DPD simulations and on available experimental results, we propose a simple velocity-slip model that can be used in conjunction with continuum-based simulations.
Keywords
This publication has 38 references indexed in Scilit:
- Predicting human blood viscosity in silicoProceedings of the National Academy of Sciences, 2011
- Cellular flow in a small blood vesselJournal of Fluid Mechanics, 2011
- Blood Flow and Cell-Free Layer in MicrovesselsMicrocirculation, 2010
- A Multiscale Red Blood Cell Model with Accurate Mechanics, Rheology, and DynamicsBiophysical Journal, 2010
- Steady shear rheometry of dissipative particle dynamics models of polymer fluids in reverse Poiseuille flowThe Journal of Chemical Physics, 2010
- Flow-induced clustering and alignment of vesicles and red blood cells in microcapillariesProceedings of the National Academy of Sciences, 2009
- Hematocrit, Volume Expander, Temperature, and Shear Rate Effects on Blood ViscosityAnesthesia & Analgesia, 2000
- ASME Centennial Historical Perspective Paper: Mechanics of Blood FlowJournal of Biomechanical Engineering, 1981
- Mechanics and Thermodynamics of BiomembranesJournal of Biomechanical Engineering, 1980
- A Single Formula for the “Law of the Wall”Journal of Applied Mechanics, 1961