Influence of lubrication modes on residual stresses generation in drilling of 316L, 15-5PH and Inconel 718 alloys
Authors:
- Mathieu GirinonMGMathieu Girinon
- Florian DumontFDFlorian Dumont
- Frederic ValiorgueFVFrederic Valiorgue
- Joël RechJRJoël Rech
- Eric FeulvarchEFEric Feulvarch
- F. LefebvreFLF. Lefebvre
- H. KaraouniHKH. Karaouni
- E. JourdenEJE. Jourden
Open Access
- 1 January 2018
- journal article
- Published by Elsevier in Procedia CIRP
- Vol. 71, 41-46
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- Heat transferred to the workpiece based on temperature measurements by IR technique in dry and lubricated drilling of Inconel 718Applied Thermal Engineering, 2016
- Analytical modeling of thrust force and torque in drillingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Measuring temperature of rotating cutting tools: Application to MQL drilling and dry milling of aerospace alloysApplied Thermal Engineering, 2012
- Contribution to dynamic characteristics of the cutting temperature in the drilling process considering one dimension heat flowApplied Thermal Engineering, 2011
- Development of infrared radiation pyrometer with optical fibers—Two-color pyrometer with non-contact fiber couplerCIRP Annals, 2008
- Temperature Measurement of Cutting Edge in Drilling -Effect of Oil Mist-CIRP Annals, 2007
- Analysis of temperature during drilling of Ti6Al4V with minimal quantity of lubricantJournal of Materials Processing Technology, 2006
- Chip thickening in deep-hole drillingInternational Journal of Machine Tools and Manufacture, 2006
- Continuous chip formation in drillingInternational Journal of Machine Tools and Manufacture, 2005
- A Method for Measuring the Temperature Distribution Along the Cutting Edges of a DrillJournal of Manufacturing Science and Engineering, 2002