Energy Efficient Thermal Management of Electronic Components Using Solid–Liquid Phase Change Materials
Authors:
- Y.K. JoshiYJY.K. Joshi
- 1 December 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 4 (4) , 641-649
Abstract
Energy efficiency is becoming a key issue in the development of thermal management devices. To this end, thermal performance of plate fin and pin fin heat sinks incorporating a solid-liquid phase change material (PCM) has been evaluated, under periodic power inputs simulating actual heating conditions. Experiments were performed using Wood's metal (50Bi/27Pb/13Sn/10Cd, melting point: 70.0/spl deg/C) under forced convection in a wind tunnel, and also with an integrated fan. A periodic on/off power of 35 W and constant air velocities in the range of 0.5-1.5 m/s were examined. Three different periodic power patterns were utilized. A thermal stabilization period was observed during the phase change from solid to liquid, during which the temperature rise was arrested. The resulting extended operating period, prior to reaching a prescribed maximum temperature, resulted in an improvement in the allowable passive thermal operation time of the heat sinks. The experiments for fan-cooled heat sinks showed that energy savings by using PCM heat sinks were in the range of 5.4-12.4%. Computational predictions were performed using an implicit enthalpy-porosity approach, and were in good agreement with experimental data.Keywords
This publication has 13 references indexed in Scilit:
- A novel hybrid heat sink using phase change materials for transient thermal management of electronics2004
- PCM thermal control unit for portable electronic devices: experimental and numerical studiesIEEE Transactions on Components and Packaging Technologies, 2003
- Least-energy optimization of forced convection plate-fin heat sinksIEEE Transactions on Components and Packaging Technologies, 2003
- Passive cooling of small telecommunication enclosures. Case study and practical approach2002
- Melting in a side heated tall enclosure by a uniformly dissipating heat sourceInternational Journal of Heat and Mass Transfer, 2001
- Convective Heat Transfer from a Multichip Module with Different Chip Spaces to PCM Slurry Flow in a Rectangular Channel.JSME International Journal Series B, 2000
- Analytical forced convection modeling of plate fin heat sinks1999
- Application of Phase Change Materials to Thermal Control of Electronic Modules: A Computational StudyJournal of Electronic Packaging, 1997
- Transient state study of electric motor heating and phase change solid-liquid coolingApplied Thermal Engineering, 1997
- ENTHALPY-POROSITY TECHNIQUE FOR MODELING CONVECTION-DIFFUSION PHASE CHANGE: APPLICATION TO THE MELTING OF A PURE METALNumerical Heat Transfer, 1988