Tool Temperature in Titanium Drilling
Authors:
- 1 April 2007
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 129 (4) , 740-749
Abstract
The spatial and temporal distribution of tool temperature in drilling of commercially pure titanium is studied using the inverse heat transfer method. The chisel and cutting edges of a spiral point drill are treated as a series of elementary cutting tools. Using the oblique cutting analysis of the measured thrust force and torque, the forces and frictional heat generation on elementary cutting tools are calculated. Temperatures measured by thermocouples embedded on the drill flank face are used as the input for the inverse heat transfer analysis to calculate the heat partition factor between the drill and chip. The temperature distribution of the drill is solved by the finite element method and validated by experimental measurements with good agreement. For titanium drilling, the drill temperature is high. At 24.4 m/min and 73.2 m/min drill peripheral cutting speed, the peak temperature of the drill reaches 480°C and 1060°C, respectively, after 12.7 mm depth of drilling with 0.025 mm feed per cutting tooth. The steady increase of drill temperature versus drilling time is investigated.Keywords
This publication has 26 references indexed in Scilit:
- High-throughput drilling of titanium alloysInternational Journal of Machine Tools and Manufacture, 2007
- The location of the maximum temperature on the cutting edges of a drillInternational Journal of Machine Tools and Manufacture, 2006
- Continuous chip formation in drillingInternational Journal of Machine Tools and Manufacture, 2005
- Dry drilling of alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2005
- An analytical finite element technique for predicting thrust force and torque in drillingInternational Journal of Machine Tools and Manufacture, 2004
- The effects of thermal distortions on the diameter and cylindricity of dry drilled holesInternational Journal of Machine Tools and Manufacture, 2001
- Titanium alloys and their machinability—a reviewJournal of Materials Processing Technology, 1997
- Analytical and Experimental Studies of Drill TemperaturesJournal of Engineering for Industry, 1994
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- Drill Temperature Distributions by Numerical SolutionsJournal of Engineering for Industry, 1971