Study of the High-Efficiency Ejecting-Explosion EDM of SiCp/Al Composite
Open Access
- 27 June 2023
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 14 (7) , 1315
Abstract
SiCp/Al composites have excellent physical properties and are widely used in aerospace and other fields. Because of their poor machinability, they are often machined by non-traditional machining methods such as electrical discharge machining (EDM). In the process of EDM, due to the “shielding” effect of the reinforced particles of SiC, the local ejection force is low during the processing process, and it is difficult to throw the reinforced particles smoothly, which ultimately leads to a low material removal rate and poor surface quality. In this paper, a high–low-voltage composite ejecting-explosion EDM power supply is developed to explore the explosive effect of reinforced particles in the ejecting-explosion EDM process and the unique process law of the explosion process. The experiment platform uses self-developed CNC machining machine tools based on an ejecting-explosive EDM power supply, and the influence of a detonation-increasing wave on the processing of SiCp/Al composites with different volume fractions was studied by changing four factors: the open-circuit voltage difference, pulse current difference, pulse phase difference, and pulse width difference of the back wave behind the step front. The material removal rate and surface roughness were measured. The research results showed that the material removal rate could be increased to 164.63%, and the material surface roughness could be increased to 30.03% by adjusting the high and low pulse current difference from 1 A to 8 A. When the voltage difference between high and low wave (HLW) pulses increases from 40 V to 120 V, the material removal rate can be increased to 150.39%, and the material surface roughness can be increased to 20.49%. The material removal rate increases with the increase in pulse phase difference and open-circuit voltage difference. With the increase in peak current difference and pulse width difference, the material removal rate becomes faster at first and then slower. The surface roughness of materials increases with the growth of open-circuit voltage difference, peak current difference, pulse width difference, and pulse phase difference.Keywords
Funding Information
- National Natural Science Foundation of China (51875074, 2022-MS-340, 2021921025)
- the General Program of Natural Science Foundation of Liaoning Province (51875074, 2022-MS-340, 2021921025)
- Liaoning BaiQianWan Talents Program (51875074, 2022-MS-340, 2021921025)
This publication has 19 references indexed in Scilit:
- Study on productivity and aerosol emissions of magnetic field-assisted EDM process ofcomposite with high volume fractionsJournal of Cleaner Production, 2021
- Empirical modeling of material removal rate and surface roughness of OHNS steel using Cu-TiB2Tool in EDMMaterials Today: Proceedings, 2021
- Investigation on spark electrical discharge machining of Si3N4 based advanced conductive ceramic compositesMaterials Today: Proceedings, 2020
- A Bipolar Pulse Power Generator for Micro-EDMProcedia CIRP, 2018
- Study of Influence of Process Parameters in Electric Discharge Machining of Aluminum – Red Mud Metal Matrix CompositeProcedia Manufacturing, 2018
- Development of a novel micro w-EDM power source with a multiple Resistor-Capacitor (mRC) relaxation circuit for machining high-melting point, -hardness and -resistance materialsJournal of Materials Processing Technology, 2017
- Optimization of EDM Process parameters in Machining of 17-4 PH Steel using Taguchi MethodMaterials Today: Proceedings, 2017
- Study of EDM cutting of single crystal silicon carbidePrecision Engineering, 2014
- Dislocation density and flow stress modeling of nanostructured Al–SiCp composite during accumulative roll bondingComputational Materials Science, 2013
- Machining characteristics of micro EDM in water using high frequency bipolar pulseInternational Journal of Precision Engineering and Manufacturing, 2011