Engineering the residual stress state of the metastable austenitic stainless steel (MASS) disc springs by incremental sheet forming (ISF)
- 5 December 2018
- journal article
- research article
- Published by Springer Nature in Production Engineering
- Vol. 13 (2) , 139-148
Abstract
No abstract availableKeywords
Funding Information
- Deutsche Forschungsgemeinschaft (BA 4253/6-1, WA 1672/31-1)
This publication has 24 references indexed in Scilit:
- A new method for modelling the support effect under rotating bending fatigue: application to Ti‐6Al‐4V alloy, with and without shot peeningFatigue & Fracture of Engineering Materials & Structures, 2013
- Non‐destructive subsurface damage monitoring in bearings failure mode using fractal dimension analysisIndustrial Lubrication and Tribology, 2012
- Investigation of shot-peened austenitic stainless steel 304L by means of magnetic Barkhausen noiseMaterials Science and Engineering: A, 2010
- An overview of stabilizing deformation mechanisms in incremental sheet formingJournal of Materials Processing Technology, 2009
- Formation of shear bands and strain-induced martensite during plastic deformation of metastable austenitic stainless steelsActa Materialia, 2007
- High cycle fatigue behavior prediction of shot-peened partsInternational Journal of Fatigue, 2004
- Influence of residual stress on the load–deflection curve of diaphragm springs for automobile clutchesJSAE Review, 2003
- Cyclic deformation and near surface microstructures of shot peened or deep rolled austenitic stainless steel AISI 304Materials Science and Engineering: A, 1999
- Cyclic deformation and near surface microstructures of normalized shot peened steel SAE 1045Materials Science and Engineering: A, 1998
- Hole-drilling strain-gage method of measuring residual stressesExperimental Mechanics, 1966