Thickness of Cubic Surface Phase on Barium Titanate Single‐Crystalline Grains
- 1 June 1994
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 77 (6) , 1665-1668
Abstract
The crystallographic structure of BaTiO3 particles prepared by conventional solid‐state reaction has been investigated by X‐ray diffractometry and dielectric measurements. The systematic analysis of the diffraction pattern has clearly shown the coexistence of tetragonal and cubic phases at room temperature. The relative amount of cubic phase increases and the dielectric constant decreases with decreasing particle size. These experimental results are consistent with the model that the cubic phase is located at the surface of BaTiO3 grains. The thickness of the surface layer is estimated to be approximately 5 nm, irrespective of the grain size.Keywords
This publication has 17 references indexed in Scilit:
- Interface defect chemistry of oxide ceramic materials. Unresolved problemsSolid State Ionics, 1991
- Dependence of the Crystal Structure on Particle Size in Barium TitanateJournal of the American Ceramic Society, 1989
- Equilibration processes at NiO surfacesSurface and Interface Analysis, 1988
- Barium titanate based ceramic materials for dielectric useInternational Journal of High Technology Ceramics, 1987
- Tracer diffusion studies in NiO bicrystals and polycrystalsJournal of Materials Science, 1986
- Seebeck effect of undoped and Cr-doped NiOSolid State Ionics, 1984
- Electron spectroscopy in studies of surface segregation of Cr in Cr-doped CoOApplications of Surface Science, 1984
- Phase relationships in the zirconia-yttria systemJournal of Materials Science, 1975
- Change from Metastable Cubic to Stable Tetragonal Form of Submicron Barium TitanateBulletin of the Chemical Society of Japan, 1974
- Resistivity Anomaly in Doped Barium TitanateJournal of the American Ceramic Society, 1964