3D Finite Element Simulation of Micro End-Milling by Considering the Effect of Tool Run-Out
Open Access
- 16 June 2017
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 8 (6) , 187
Abstract
Understanding the micro milling phenomena involved in the process is critical and difficult through physical experiments. This study presents a 3D finite element modeling (3D FEM) approach for the micro end-milling process on Al6082-T6. The proposed model employs a Lagrangian explicit finite element formulation to perform coupled thermo-mechanical transient analyses. FE simulations were performed at different cutting conditions to obtain realistic numerical predictions of chip formation, temperature distribution, and cutting forces by considering the effect of tool run-out in the model. The radial run-out is a significant issue in micro milling processes and influences the cutting stability due to chip load and force variations. The Johnson–Cook (JC) material constitutive model was applied and its constants were determined by an inverse method based on the experimental cutting forces acquired during the micro end-milling tests. The FE model prediction capability was validated by comparing the numerical model results with experimental tests. The maximum tool temperature was predicted in a different angular position of the cutter which is difficult or impossible to obtain in experiments. The predicted results of the model, involving the run-out influence, showed a good correlation with experimental chip formation and the signal shape of cutting forces.Keywords
This publication has 42 references indexed in Scilit:
- Modelling and simulation of micro-milling cutting forcesJournal of Materials Processing Technology, 2010
- Three-dimensional temperature predictions in machining processes using finite difference methodJournal of Materials Processing Technology, 2009
- The influence of Johnson–Cook material constants on finite element simulation of machining of AISI 316L steelInternational Journal of Machine Tools and Manufacture, 2007
- The influence of friction models on finite element simulations of machiningInternational Journal of Machine Tools and Manufacture, 2006
- A comparison of orthogonal cutting data from experiments with three different finite element modelsInternational Journal of Machine Tools and Manufacture, 2004
- An integral method to determine the mechanical behavior of materials in metal cuttingJournal of Materials Processing Technology, 2003
- Material behaviour in conditions similar to metal cutting: flow stress in the primary shear zoneJournal of Materials Processing Technology, 2002
- Modeling micro-end-milling operations. Part II: tool run-outInternational Journal of Machine Tools and Manufacture, 2000
- SIMULTANEOUS MEASUREMENT OF THE THERMAL AND TRIBOLOGICAL EFFECTS OF CUTTING FLUIDMachining Science and Technology, 1999
- The Formation and Properties of Machining BurrsJournal of Engineering for Industry, 1976