Rotor temperature distribution measuring system
Authors:
- 1 November 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 2006-2011
Abstract
The work proposes instrumentation for measuring local temperatures on the surface and in the interior of a rotor. The applied design incorporates up to 12 simultaneous local temperature measurements on arbitrary locations in the rotor. Thus, a realistic 3D thermal distribution picture of the rotor can be obtained. The system characterizes with accuracy of α1.5 °C, noise immunity under inverter operation, continuous measuring durations of up to 30h and mechanical rigidity for up to 6000 rpm rotor speed. The mechanical assembly is appropriate for laboratory setups since adaptation on the motor are required. Experimental results, conducted on an induction motor and permanent-magnet synchronous motor, are presented to demonstrate system feasibility.Keywords
This publication has 19 references indexed in Scilit:
- Improved synchronous machine thermal modelling2008
- Design and Construction of Induction Motor Thermal Monitoring System2006
- The Application of Wireless Sensor Networks for Fault Condition Monitoring in Three-Phase Induction Motors2006
- The research on the network optical fiber sensor of the surface temperature measurement for a large rotor based on IEEE1451.22005
- Measurement of physical signals in rotating part of electrical machine by means of optical fibre transmission2002
- A new thermal observer for squirrel-cage induction motor2002
- Run-time power control scheme using software feedback loop for low-power real-time application2000
- Monitoring permanent-magnet motor heating with phosphor thermometryIEEE Transactions on Instrumentation and Measurement, 1988
- A Rotor Condition Monitor for Squirrel-Cage Induction MachinesIEEE Transactions on Industry Applications, 1987
- Thermal Relationships in an Induction Motor under Normal and Abnormal OperationTransactions of the American Institute of Electrical Engineers. Part III: Power Apparatus and Systems, 1961