Prediction method of hole expansion limit for 6000 series aluminum alloy sheet
Open Access
- 15 December 2022
- journal article
- research article
- Published by Japan Institute of Light Metals in Journal of Japan Institute of Light Metals
- Vol. 72 (12) , 702-707
Abstract
This study investigates the applicability of the forming limit strain (FLS) and fracture limit strain (FrLS) determined from uniaxial tensile tests for predicting the hole expansion limit of a 6000-series aluminum alloy sheet. Since the stress state at the hole edge in hole expansion is uniaxial, the FLSs and FrLSs of the test sample are determined from the uniaxial tensile tests at various cut angles from the rolling direction. The experimental methods for determining the FLS and FrLS are presented. In the hole expansion experiment, the development of the strain distribution at a position 3 mm apart from the hole edge was precisely measured using digital image correlation method for three different hole diameters, and the maximum principal strain along the hole edge, ε1, was compared with the FLS and FrLS. We have confirmed that the fracture in the hole expansion experiment always occurred at the hole edge and when ε1 reached the FrLS, regardless of the hole diameter. Therefore, the FrLS can be a criterion for predicting the hole expansion limit of the test sample.Keywords
This publication has 4 references indexed in Scilit:
- On the expansion of a circular hole in an orthotropic elastoplastic thin sheetInternational Journal of Mechanical Sciences, 2020
- Material modeling of 6016-O and 6016-T4 aluminum alloy sheets and application to hole expansion forming simulationInternational Journal of Plasticity, 2017
- Plastic deformation characteristics of light metal sheets—methods of measurement and modeling—Journal of Japan Institute of Light Metals, 2015
- Effect of anisotropic yield functions on the accuracy of hole expansion simulationsJournal of Materials Processing Technology, 2011