Numerical and experimental investigation on the depressurization capacity of a new type of depressure-dominated jet mill bit
Open Access
- 16 June 2020
- journal article
- research article
- Published by Elsevier in Petroleum Science
- Vol. 17 (6) , 1602-1615
Abstract
Efficient cuttings transport and improving rate of penetration (ROP) are two major challenges in horizontal drilling and extended reach drilling. A type of jet mill bit (JMB) may provide an opportunity to catch the two birds with one stone: not only enhancing cuttings transport efficiency but also improving ROP by depressuring at the bottom hole. In this paper, the JMB is further improved and a new type of depressure-dominated JMB is presented; meanwhile, the depressurization capacity of the depressure-dominated JMB is investigated by numerical simulation and experiment. The numerical study shows that low flow-rate ratio helps to enhance the depressurization capacity of the depressure-dominated JMB; for both depressurization and bottom hole cleaning concern, the flow-rate ratio is suggested to be set at approximately 1:1. With all other parameter values being constant, lower dimensionless nozzle-to-throat-area ratio may result in higher depressurization capacity and better bottom hole cleaning, and the optimal dimensionless nozzle-to-throat-area ratio is at approximately 0.15. Experiments also indicate that reducing the dimensionless flow-rate ratio may help to increase the depressurization capacity of the depressure-dominated JMB. This work provides drilling engineers with a promising tool to improve ROP.Keywords
This publication has 20 references indexed in Scilit:
- A Method for Optimizing Jet-Mill-Bit Hydraulics in Horizontal DrillingSPE Journal, 2016
- Experimental and numerical simulation of cuttings transportation in coiled tubing drillingJournal of Natural Gas Science and Engineering, 2016
- Optimal design of jet mill bit for jet comminuting cuttings in horizontal gas drilling hard formationsJournal of Natural Gas Science and Engineering, 2016
- A new method for determining the minimum gas injection rate required for hole cleaning in horizontal gas drillingJournal of Natural Gas Science and Engineering, 2014
- Drilling Characteristics of Combinations of Different High Pressure Jet NozzlesJournal of Hydrodynamics, 2011
- Research and application of water jet technology in well completion and stimulation in ChinaPetroleum Science, 2010
- Limit analysis of extended reach drilling in South China SeaPetroleum Science, 2009
- Technical Feasibility and Applicability of a Concentric Jet Pump in Underbalanced Drilling2004
- The Effects of Particle Size, Fluid Rheology, and Pipe Eccentricity on Cuttings Transport2000
- Experimental Investigation of Drilled Cuttings Transport in Inclined Boreholes1990