Weak bond effects in adhesively bonded joints between the dissimilar adherends
- 11 December 2019
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 97 (8) , 760-782
Abstract
Adhesively bonded joints provide uniform stress distributions for the width in the bonded region, which is preferred for lightweight assemblages in aircraft structures, but the bonded region is hidden between adherends and suffers due to the existence of weak bonds. Adhesively bonded joints between dissimilar adherends are susceptible to weak bonds due to large differences in the properties and behaviour of adherends. Weak bonds present at the interfaces due to improper curing of adhesive, may go undetected and affect the bond strength. In this paper, an attempt has been made to characterize weak bond effects in adhesive bonded joints between dissimilar adherends. Adhesively bonded single lap joint specimens have been fabricated with CFRP and aluminium using Araldite-2015 adhesive with varied areas of weak bond. PTFE (polytetrafluoroethylene) films used to introduce weak bonds in the bonded region. X-ray radiography and ultrasonic tests have been performed on specimens to verify the presence of weak bond areas. Uniaxial tensile tests have been conducted on specimens to evaluate the mechanical response of adhesive joints in the presence of weak bonds and to obtain failure loads and corresponding failure patterns. Finite element analysis has been carried out to evaluate variations of peel and shear stresses along the bond length. From the studies, it is found that failure occurs at the interface where weak bonds are present irrespective of dimensions of weak bonds and the corresponding failure load decreases with increase in the weak bond area resulting in interface failure.Keywords
This publication has 24 references indexed in Scilit:
- Effects of residual oils on the adhesion characteristics of metal-CFRP adhesive jointsComposite Structures, 2019
- Identification of an effective nondestructive technique for bond defect determination in laminate composites—A technical reviewJournal of Composite Materials, 2018
- An updated review of adhesively bonded joints in composite materialsInternational Journal of Adhesion and Adhesives, 2017
- Identification of kissing defects in adhesive bonds using infrared thermographyInternational Journal of Adhesion and Adhesives, 2016
- Effect of material, geometry, surface treatment and environment on the shear strength of single lap jointsInternational Journal of Adhesion and Adhesives, 2009
- Adhesively bonded joints in composite materials: An overviewProceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, 2009
- The detectability of kissing bonds in adhesive joints using ultrasonic techniquesUltrasonics, 2003
- The Correlation of Non-Destructive Measurements and Toughness Changes in Adhesive Joints during Environmental AttackThe Journal of Adhesion, 2001
- Detection of kissing bonds by Lamb wavesUltrasonics, 1998
- Nondestructive testing of adhesively-bonded jointsNDT & E International, 1997