Creep-Driven Solute Segregation to Planar Faults in Ni-Base Single-Crystal Superalloys
Open Access
- 10 April 2026
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 57 (5) , 1813-1823
Abstract
This study proposes that creep-induced segregation to planar faults reflects the dynamic establishment of a new compositional steady state within the two-phase $$\gamma $$ / $$\gamma ^{\prime }$$ single-crystal Ni-base superalloy during creep. The temperature difference between the alloy’s aging condition and the creep-experiment temperature drives a creep-induced partitioning flux, causing elements to redistribute within the $$\gamma ^{\prime }$$ phase and accumulate at planar faults. In this work, the single-crystal Ni-base superalloy ERBO-1 (SX) was creep-deformed using double-shear creep testing at 250 MPa and 750 °C, which is 120 °C below the preceding aging treatment temperature. At 1 and 2 pct strain, the interrupted creep states show planar faults with solute segregation as commonly observed in this low-temperature, high-stress regime. Solute segregation at superlattice extrinsic stacking faults (SESF), anti-phase boundaries (APB), and microtwins in the $$\gamma ^{\prime }$$ phase reveals systematic depletion of Ni and Al, accompanied by enrichment of Re, Co, Cr, Mo, and Ti. Thermodynamic calculations predict the temperature-dependent $$\gamma $$ / $$\gamma ^{\prime }$$ compositions. Under the present experimental conditions, this results in increased uptake of Ni and Al and rejection of Re, Co, and Cr by the $$\gamma ^{\prime }$$ phase. Consequently, depletion of Ni and Al and enrichment of Re, Co, and Cr are detected at planar defect sites. In contrast, Ti, Mo, Ta, and W segregation at microtwins and SESFs cannot be explained by bulk $$\gamma ^{\prime }$$ partitioning and is instead attributed to localized phase transformations in the vicinity of the defects.
Keywords
Funding Information
- Karlsruher Institut für Technologie (KIT)
This publication has 39 references indexed in Scilit:
- A Review on the Partitioning of Solutes Along Dislocations and Stacking Faults in SuperalloysMetallurgical and Materials Transactions A, 2024
- Atomic Structure and Chemical Composition of Planar Fault Structures in Co-Base Superalloys2020
- On Shear Testing of Single Crystal Ni-Base SuperalloysMetallurgical and Materials Transactions A, 2018
- Segregation and Phase Transformations Along Superlattice Intrinsic Stacking Faults in Ni-Based SuperalloysMetallurgical and Materials Transactions A, 2018
- Segregation-Assisted Plasticity in Ni-Based SuperalloysMetallurgical and Materials Transactions A, 2018
- On Local Phase Equilibria and the Appearance of Nanoparticles in the Microstructure of Single‐Crystal Ni‐Base SuperalloysAdvanced Engineering Materials, 2016
- Creep-induced planar defects in L12-containing Co- and CoNi-base single-crystal superalloysActa Materialia, 2015
- Creep deformation-induced antiphase boundaries in L1 2 -containing single-crystal cobalt-base superalloysActa Materialia, 2014
- Advanced Scale Bridging Microstructure Analysis of Single Crystal Ni‐Base SuperalloysAdvanced Engineering Materials, 2014
- The influence of the fault energies on the anomalous mechanical behaviour of Ni3Al alloysActa Materialia, 1996