The use of recycled printed circuit boards as reinforcing fillers in the polyester composite
Authors:
- 1 July 1996
- journal article
- research article
- Published by Taylor & Francis in Journal of Environmental Science and Health . Part A: Environmental Science and Engineering and Toxicology
- Vol. 31 (6) , 1345-1359
Abstract
The feasibility of using recycled printed circuit boards (PCB) as reinforcing fillers in manufacturing unsaturated polyester (UP) composites was studied using differential scanning calorimetry (DSC), and mechanical test. The concentrations of Cu leached from the molded products were also tested. From the DSC measurement, it was obtained that the addition of PCB affected the free radical reaction of the UP resin and decreased curing rates at the beginning stage. The methods of surface treatments also affected the curing kinetics of the UP resin. PCB modified UP resins had higher Tg, and were tougher and stronger than the plain UP because of energy dissipation effects from glass fibers and rigid epoxy resins in the PCB. The impact energy of the specimen increased with increasing the loading of PCB fillers. The size of PCB fillers and the type of surface treatments affected the mechanical properties and the concentrations of copper leached from molded products. As much as 150 parts per hundred PCB could be added in the UP without violating the environmental regulation. However, the addition of PCB darkened the appearance of the molded specimen. Production of UP composites from waste PCB was justified.Keywords
This publication has 12 references indexed in Scilit:
- The elastic modulus of filled polymer compositesJournal of Applied Polymer Science, 1993
- Crack propagation in a glass particle-filled epoxy resinJournal of Materials Science, 1984
- Crack propagation in a glass particle-filled epoxy resinJournal of Materials Science, 1984
- Fracture, strength and fatigue of filled thermoset compositesBritish Polymer Journal, 1982
- Mechanisms of fracture in filled thermosetting resinsBritish Polymer Journal, 1980
- Mechanical and fracture behaviour of glass bead filled epoxy compositesMaterials Science and Engineering, 1975
- The strength of polymeric composites containing spherical fillersJournal of Applied Polymer Science, 1974
- Effect of rubber particle size on deformation mechanisms in glassy epoxyPolymer Engineering & Science, 1973
- Mechanical properties of particulate compositesPolymer Engineering & Science, 1972
- The effect of interfacial bonding on the toughness of glass filled polymersMaterials Science and Engineering, 1971