Near‐UV laser treatment of extrinsic dental enamel stains
- 13 March 2012
- journal article
- research article
- Published by Wiley in Lasers in Surgery and Medicine
- Vol. 44 (4) , 339-345
Abstract
Background and Objectives: The selective ablation of extrinsic dental enamel stains using a 400‐nm laser is evaluated at several fluences for completely removing stains with minimal damage to the underlying enamel.Study Design/Materials and Methods: A frequency‐doubled Ti:sapphire laser (400‐nm wavelength, 60‐nanosecond pulse duration, 10‐Hz repetition rate) was used to treat 10 extracted human teeth with extrinsic enamel staining. Each tooth was irradiated perpendicular to the surface in a back‐and‐forth motion over a 1‐mm length using an ∼300‐µm‐diam 10th‐order super‐Gaussian beam with fluences ranging from 0.8 to 6.4 J/cm2. Laser triangulation determined stain depth and volume removed by measuring 3D surface images before and after irradiation. Scanning electron microscopy evaluated the surface roughness of enamel following stain removal. Fluorescence spectroscopy measured spectra of unbleached and photobleached stains in the spectral range of 600–800 nm.Results: Extrinsic enamel stains are removed with laser fluences between 0.8 and 6.4 J/cm2. Stains removed on sound enamel leave behind a smooth enamel surface. Stain removal in areas with signs of earlier cariogenic acid attacks resulted in isolated and randomly located laser‐induced, 50‐µm‐diam enamel pits. These pits contain 0.5‐µm diam, smooth craters indicative of heat transfer from the stain to the enamel and subsequent melting and water droplet ejection. Ablation stalling of enamel stains is typically observed at low fluences (2) and is accompanied by a drastic reduction in porphyrin fluorescence from the Soret band.Conclusion: Laser ablation of extrinsic enamel stains at 400 nm is observed to be most efficient above 3 J/cm2 with minimal damage to the underlying enamel. Unsound underlying enamel is also observed to be selectively removed after irradiation. Lasers Surg. Med. 44:339–345, 2012.Keywords
Funding Information
- University of Rochester
- New York State Energy Research and Development Authority
- American Society for Laser Medicine and Surgery
- U.S. Department of Energy Office of Inertial Confinement Fusion under Cooperative Agreement (DE-FC52-08NA28302)
This publication has 36 references indexed in Scilit:
- Evaluation of physical properties of enamel after microabrasion, polishing, and storage in artificial salivaBiomedical Materials, 2011
- Near-ultraviolet removal rates for subgingival dental calculus at different irradiation anglesJournal of Biomedical Optics, 2011
- Investigation into the optimum beam shape and fluence for selective ablation of dental calculus at λ = 400 nmLasers in Surgery and Medicine, 2010
- Real-time detection of dental calculus by blue-LED-induced fluorescence spectroscopyJournal of Photochemistry and Photobiology B: Biology, 2007
- The bleaching of teeth: A review of the literatureJournal of Dentistry, 2006
- Residual Caries Detection Using Visible FluorescenceCaries Research, 2002
- Thermal and chemical modification of dentin by 9–11‐μm CO2 laser pulses of 5–100‐μs durationLasers in Surgery and Medicine, 2002
- Spatial chemical analysis of dental stain using wavelength dispersive spectrometryEuropean Journal of Oral Sciences, 1998
- Nature of light scattering in dental enamel and dentin at visible and near-infrared wavelengthsApplied Optics, 1995
- Investigations into Black Extrinsic Tooth StainJournal of Dental Research, 1977