Extraction of Attenuation Parameter in Periodic Shorted Reflectors of One-Port SAW Resonator Using Scattering Matrix Approach
- 4 January 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 72 (00189456) , 1-4
Abstract
In this work, the well-known scattering matrix approach to design of one-port SAW resonators is adapted towards extraction of the coupling-of-modes (COM) attenuation parameter, α for Rayleigh SAW propagation on a periodic shorted aluminium grating. The attenuation close to resonance inside the reflectors of the one-port SAW resonator is extracted by matching the measured conductance of the resonator to its version calculated from the experimentally measured IDT scattering coefficients, intrinsic substrate parameters and geometry of the resonator. Based on the extracted value of α, it was observed that the proposed method could predict the unloaded Q-factor of the resonator at a minor discrepancy of ~7.02%. At the same time, since the proposed method utilizes the measured IDT scattering coefficients to consider the effect of IDT losses on the measured conductance of the resonator, it offers a convenient scheme to directly extract the attenuation of SAW contributed by the reflectors of the device through numerical means while operating purely in the frequency domain. The proposed method could be applied to quantify the increase in attenuation caused by viscous damping of SAW inside sensing film-coated reflectors of one-port SAW resonator sensors and thereby, aid to optimize the sensing film thickness to deploy these devices for high-resolution frequency-based sensing applications.Keywords
Funding Information
- CREST Malaysia (P04C1-20, CNI-00019)
This publication has 14 references indexed in Scilit:
- A high-performance lab-on-a-chip liquid sensor employing surface acoustic wave resonanceJournal of Micromechanics and Microengineering, 2017
- Microfabrication of surface acoustic wave device using UV LED photolithography techniqueMicroelectronic Engineering, 2014
- Extraction of the SAW attenuation parameter in periodic reflecting gratingsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Scattering matrix approach to STW resonatorsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2002
- COUPLING-OF-MODES ANALYSIS OF SAW DEVICESInternational Journal of High Speed Electronics and Systems, 2000
- Scattering matrix approach to one-port SAW resonatorsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2000
- Dynamics and Response of Polymer-Coated Surface Acoustic Wave Devices: Effect of Viscoelastic Properties and Film ResonanceAnalytical Chemistry, 1994
- Experimental measurements of propagation, attenuation, reflection and scattering of leaky waves in Al electrode gratings on 41°, 52° and 64°-LiNbO31993
- Modelling the transverse-mode response of a two-port SAW resonatorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1991
- Surface acoustic wave probes for chemical analysis. II. Gas chromatography detectorAnalytical Chemistry, 1979