Real time implementation of DTC based on sliding mode speed controller of an induction motor
- 1 December 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 94-100
Abstract
This research work deals with the real time implementation on an Field Programmable Gate Array (FPGA) of the Direct Torque Control (DTC) of an Induction Motor (IM) utilizing a Sliding Mode controller (SMC) of the rotor speed. In several industrial applications, the speed is controlled by a Proportional Integral (PI) regulator, because of its simplicity. However, because of the model uncertainties of the motor, the stator resistance variation, and the variation of the load torque as an external disturbance, the PI controller becomes unable to guarantee the desired control performances. To overcome the PI insufficiency the SMC is proposed. SMC is featured by its capability to cope with the disturbances. Therefore, developing the SMC of speed presents the first contribution in this manuscript. The second contribution consists to implement the proposed approach referred as DTC-SMC using an FPGA due to its ability to execute this algorithm with high processing speed by adopting a parallel processing. The FPGA is proposed to overcome the DSPs and microcontrollers limitations, like the calculation delay due to its sequential processing. The DTC-SMC algorithm has been validated by simulation utilizing the Xilinx System Generator (XSG). The obtained results of simulation verify the proposed controller relative to the PI controller under load torque disturbances.Keywords
This publication has 10 references indexed in Scilit:
- Design and Implementation of Direct Torque Control Based on an Intelligent Technique of Induction Motor on FPGAJournal of Electrical Engineering & Technology, 2015
- FPGA-Based Implementation Direct Torque Control of Induction MotorInternational Journal of Power Electronics and Drive Systems (IJPEDS), 2015
- Fingerprint Image Processing Acceleration Through Run-Time Reconfigurable HardwareIEEE Transactions on Circuits and Systems II: Express Briefs, 2010
- Implementation of a New Torque and Flux Controllers for Direct Torque Control (DTC) of Induction Machine Utilizing Digital Signal Processor (DSP) and Field Programmable Gate Arrays (FPGA)2006
- Direct torque control: a practical approach to electric vehicle2006
- A Fast Flux Search Controller for DTC Based Induction Motor Drives2005
- Extended kalman filter tuning in sensorless PMSM drivesIEEE Transactions on Industry Applications, 2003
- FOC and DTC: two viable schemes for induction motors torque controlIEEE Transactions on Power Electronics, 2002
- Optimal tuning of PID controllers for integral and unstable processesIEE Proceedings - Control Theory and Applications, 2001
- A New Quick-Response and High-Efficiency Control Strategy of an Induction MotorIEEE Transactions on Industry Applications, 1986