Current density distribution and optimization of the collection electrodes of a honeycomb wet electrostatic precipitator
Open Access
- 31 August 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (54) , 30701-30711
Abstract
Wet electrostatic precipitators (ESPs) demonstrate a robust adaptability for particulate matter control and have been confirmed to be a promising technology for removing particles and sulfuric acid aerosol from flue gas. Recent studies have shown that removing fine particles or sulfuric acid aerosol from wet ESPs requires further development. Among the components of wet ESPs, discharge electrode configurations are crucial for determining the performance of wet ESPs. This paper reports the corona discharge characteristics and removal performance of sulfuric acid aerosol using different discharge electrode configurations in a honeycomb wet ESP experimental system. Two key parameters, namely, V–I characteristics and current density distribution, with different discharge electrode geometries (e.g., electrode type, spike spacing, and spike length) and rotation angles, were investigated by using a novel electrical parameter measurement system to evaluate the effects of these parameters on corona discharge. The results showed that triple-spike and sawtooth electrodes exhibit the highest average current density. The average current density of the triple-spike electrode increased with the spike length from 10 mm to 20 mm, and the peak current density distribution on the collection electrode increased by 62.1%, but the current density decreased sharply away from the spike. Moreover, the average peak current density decreased by 30.1% when the spike spacing was 25 mm given the sharp point discharge suppression when spikes were significantly dense. The electrode configuration was optimized on the basis of the current density distribution. The highest removal efficiency of sulfuric acid aerosol was 99.2% at a specific collection area of 23.09 m2 (m3 s−1)−1.Keywords
Funding Information
- National Natural Science Foundation of China (No. 51621005, No. U1609212)
This publication has 33 references indexed in Scilit:
- Physicochemical properties and ability to generate free radicals of ambient coarse, fine, and ultrafine particles in the atmosphere of Xuanwei, China, an area of high lung cancer incidenceAtmospheric Environment, 2013
- The correlation between corona current distribution and collection of fine particles in a laboratory-scale electrostatic precipitatorJournal of Electrostatics, 2013
- Experimental study of V–I characteristics of wire–plate electrostatic precipitators under clean air conditionsJournal of Electrostatics, 2013
- Properties of RE–W cathode and its application in electrostatic precipitation for high temperature gas clean-upFuel, 2012
- Three-dimensional analysis of electrohydrodynamic flow in a spiked electrode-plate electrostatic precipitatorJournal of Electrostatics, 2011
- Characterization of sulphuric acid and ammonium sulphate aerosols in wet flue gas cleaning processesChemical Engineering and Processing - Process Intensification, 2008
- Modern electrostatic devices and methods for exhaust gas cleaning: A brief reviewJournal of Electrostatics, 2007
- Numerical simulation of three-dimensional electrohydrodynamics of spiked-electrode electrostatic precipitatorsIEEE Transactions on Dielectrics and Electrical Insulation, 2006
- Effect of the particle diameter and corona electrode geometry on the particle migration velocity in electrostatic precipitatorsJournal of Electrostatics, 2001
- Electrostatic precipitationIEEE Transactions on Dielectrics and Electrical Insulation, 2000