Characterization of Radiation Shielding Capabilities of High Concentration PLA-W Composite for 3D Printing of Radiation Therapy Collimators
Open Access
Abstract
This work evaluates the radiation shielding capabilities of the PLA-W composite for MV energy photons emitted by a linear accelerator and the feasibility of manufacturing a clinically-used collimator grid in spatially fractionated radiotherapy (SFRT) using the material extrusion (MEX) 3D printing technique. The PLA-W filament used has a W concentration of 93% w/w and a green density of 7.51 g/cm3, characteristics that make it suitable for this purpose. Relevant parameters such as the density and homogeneity distribution of W in the manufactured samples determine the mass attenuation coefficient, directly affecting the radiation shielding capacities, so different printing parameters were evaluated, such as layer height, deposition speed, nozzle temperature, and infill, to improve the protection performance of the samples. Additionally, physical and mechanical tests were conducted to ensure structural stability and spatial variability over time, which are critical to ensure precise spatial modulation of radiation. Finally, a complete collimator grid measuring 9.3 × 9.3 × 7.1 cm3 (consisting of 39 conical collimators with a diameter of 0.92 cm and center-to-center spacing of 1.42 cm) was manufactured and experimentally evaluated on a clinical linear accelerator to measure the radiation shielding and dosimetric parameters such as mass attenuation coefficient, half-value layer (HVL), dosimetric collimator field size, and inter-collimator transmission using radiochromic films and 2D diode array detectors, obtaining values of 0.04692 cm2/g, 2.138 cm, 1.40 cm, and 15.6%, respectively, for the parameters in the study. This shows the viability of constructing a clinically-used collimator grid through 3D printing.Keywords
Funding Information
- Comisión Nacional de Investigación Científica y Tecnológica (1221000, DI21-0072, DIM23-0014)
- Research Division of the UNIVERSIDAD DE LA FRONTERA through DIUFRO (1221000, DI21-0072, DIM23-0014)
- Programa de Doctorado en Ingeniería, Sede Universidad de La Frontera (1221000, DI21-0072, DIM23-0014)
This publication has 39 references indexed in Scilit:
- Effect of printing parameters on extrusion-based additive manufacturing using highly filled CuSn12 filamentThe International Journal of Advanced Manufacturing Technology, 2023
- Clinical aspects of spatially fractionated radiation therapy treatmentsPhysica Medica, 2023
- Extrusion-Based Technology in Additive Manufacturing: A Comprehensive ReviewArabian Journal for Science and Engineering, 2022
- Radiation attenuation properties of some commercial polymers for advanced shielding applications at low energiesPolymers for Advanced Technologies, 2021
- A review on the various processing parameters in FDMMaterials Today: Proceedings, 2021
- Mechanical characterization of FDM 3D printing of continuous carbon fiber reinforced PLA compositesComposites Part B: Engineering, 2019
- A ring‐based compensator IMRT system optimized for low‐ and middle‐income countries: Design and treatment planning studyMedical Physics, 2018
- Biomedical applications of additive manufacturing: Present and futureCurrent Opinion in Biomedical Engineering, 2017
- Investigation of shielding parameters for smart polymersChinese Journal of Physics, 2016
- Mechanical properties of components fabricated with open-source 3-D printers under realistic environmental conditionsMaterials & Design (1980-2015), 2014